We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten gold-tipped 4 mm banana plugs, five red and five black, spring-loaded push-button housings

KEHIPI

KEHIPI P10064-RB10PCS 4mm banana plug 10pcs red&black

SKU CH-G48D-FYDH7

Ten gold-plated 4 mm banana plugs rated 32 A at 250 V accept 0.2-2.5 mm² wire via push-button spring clamps

  • Gold-plated phosphor bronze contacts ensure low-resistance signal transfer
  • PA6 V0-rated shell resists flame and deformation up to 85 °C
  • 301 stainless-steel spring clamps 0.2–2.5 mm² wire securely
  • Push-button design terminates stripped 10 mm leads in seconds
  • 5 red and 5 black plugs rated 32 A at 250 V

Quick-connect banana plugs for 32 A circuits

These 4 mm banana plugs are rated for 32 A at 250 V and accept wire from 0.2 to 2.5 mm². The gold-plated phosphor-bronze tips and stainless-steel springs give low-resistance contact. They suit test leads, speaker cables or bench power supplies where a secure, tool-free connection is needed.

Push-button wiring with 10 mm strip length

Strip each conductor 10 mm, press the button, insert the wire to the stop and release. The internal 301 stainless-steel spring clamps the strands without a screw or solder joint. The PA6 V0 housing resists heat to 85 °C and will not propagate flame if a fault occurs.

Limited to single-pole, low-voltage use

The plugs carry 32 A only when the wire gauge and contact pressure are correct; they are not rated for mains distribution or three-phase loads. No locking collar or shroud is fitted, so they must not be used where accidental disconnection could create a hazard.

Highlights

  • Gold-plated phosphor bronze contacts ensure low-resistance signal transfer
  • PA6 V0-rated shell resists flame and deformation up to 85 °C
  • 301 stainless-steel spring clamps 0.2–2.5 mm² wire securely
  • Push-button design terminates stripped 10 mm leads in seconds
  • 5 red and 5 black plugs rated 32 A at 250 V

Specifications

BrandGoupchn
Part NumberP10064-RB10PCS

Questions about this item

How do I confirm the 32A connection is secure after wiring?

Press the push-button until it locks; the internal 301 stainless-steel spring clamps the conductor so the plug cannot pull free under load.

What comes in the pack and what extra items are required?

The box contains five red and five black 4 mm gold-plated banana plugs; you must supply 0.2–2.5 mm² wire and a stripper set to 10 mm.

Which version should I choose for 250 V / 32 A circuits?

The P10064-RB10PCS model is rated 250 V / 32 A with PA6 V0 housing and 2.0 µm gold plating, matching that requirement.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.