We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten small green circuit boards with USB ports and electronic components

KEHIPI

KEHIPI 10 PCS PFM Control DC-DC Boost Module 0.9V-5V to 5V 600mA Power Adapter

SKU CH-HFE0-7KP71

Pack of ten PFM-controlled boost modules that step 0.9–5 V input to a stable 5 V USB output at up to 600 mA with 96 % efficiency

  • TypeDigital
  • Stable 5 V output from inputs as low as 0.9 V
  • Up to 96 % conversion efficiency reduces energy waste
  • Delivers 500-600 mA from two AA batteries
  • Single AA battery provides about 200 mA for low-power devices
  • USB connector powers phones, cameras and microcontrollers directly

Ten-piece boost module kit

This pack contains ten identical DC-DC step-up modules that convert any input between 0.9 V and 5 V into a steady 5 V output. Each board integrates a miniature PFM controller chip and a USB connector for direct device power. The kit suits hobbyists building portable USB chargers from single or dual AA cells.

Solder-ready USB output

The modules arrive as bare PCBs with through-hole pads, so a soldering iron and basic wiring are required before use. Polarity must be observed on the low-voltage input side; reversing the cells will prevent operation. No firmware or configuration is involved, and the onboard USB socket accepts standard cables once the board is powered.

Efficiency under continuous draw

Conversion efficiency reaches up to 96 percent, limiting heat rise during extended operation. With two AA cells the board sustains 500 to 600 mA, while a single cell delivers roughly 200 mA before voltage sag. The PFM controller maintains regulation across the full input range without external components.

Highlights

  • Stable 5 V output from inputs as low as 0.9 V
  • Up to 96 % conversion efficiency reduces energy waste
  • Delivers 500-600 mA from two AA batteries
  • Single AA battery provides about 200 mA for low-power devices
  • USB connector powers phones, cameras and microcontrollers directly

Specifications

BrandAITRIP
Model0701715464773
TypeDigital

Questions about this item

How can I verify the boost module is working correctly after wiring it up?

Apply a DC source between 0.9 V and 5 V to the input pins, then measure the USB output with a multimeter; it should read a steady 5 V DC, and the converter will deliver 500–600 mA with two AA cells or about 200 mA with a single AA cell.

What does the 10-piece pack contain and is anything else required?

The package includes ten 0.9–5 V to 5 V boost modules, each with an onboard USB connector and PFM control chip; you only need to supply a suitable DC input such as AA batteries or another 0.9–5 V source.

Which version should I choose for a project needing the highest possible efficiency?

All ten modules share the same specification, reaching up to 96 % conversion efficiency, so any unit from the pack will provide the maximum efficiency available.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.