We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Jaspertronics replacement lamp module in black housing

Jaspertronics

Jaspertronics U3-810-LAMP DLP Replacement Lamp

SKU CH-D5A4-B7HVH

Replacement lamp and housing module for Mitsubishi U3-810 projectors, supplied new with original-specification bulb

  • TypeProject Lamp
  • Weight0.9990
  • Compatible with Mitsubishi U3-810 projectors
  • Original Jaspertronics lamp and housing module
  • Industry-leading one year warranty included
  • Brand new condition for full rated lifespan
  • Weighs .9990 for secure installation

Jaspertronics U3-810-LAMP DLP Lamp

The Jaspertronics U3-810-LAMP is a new replacement lamp module designed specifically for the Mitsubishi U3-810 projector. It arrives as a complete lamp and housing assembly ready for direct installation. This unit suits owners needing to restore brightness after the original lamp reaches end of life. It is not for users with different projector models or those seeking bare bulbs without housing.

Replaces worn Mitsubishi U3-810 lamp

This module replaces the factory lamp inside the Mitsubishi U3-810 when image dimming or a replacement warning appears. The jump is worth it when the current lamp no longer delivers adequate light output for presentations or video. It does not apply to other Mitsubishi series or third-party projectors. Buyers needing a different part code should verify compatibility before ordering.

Tool-free housing swap

Installation involves opening the projector lamp door, removing the old housing, and sliding this unit into place until it seats firmly. No tools are typically required beyond a screwdriver for the door. The most common issue is forgetting to reset the projector lamp timer after fitting, which leaves the warning active. Ensure the door latch engages fully or the projector will not power on.

Highlights

  • Compatible with Mitsubishi U3-810 projectors
  • Original Jaspertronics lamp and housing module
  • Industry-leading one year warranty included
  • Brand new condition for full rated lifespan
  • Weighs .9990 for secure installation

Specifications

BrandJaspertronics
ModelU3-810-LAMP
Part NumberU3-810-LAMP
TypeProject Lamp
Weight0.9990

Questions about this item

Will the U3-810-LAMP module fit directly into my Mitsubishi U3-810 projector without extra brackets?

The lamp-and-housing module is built to the original Mitsubishi U3-810 specification, so it slides into the projector's lamp compartment without additional brackets or adapters.

What is the correct order of steps when installing the U3-810-LAMP, and which step do users most often skip?

Power off and unplug the projector, let it cool completely, remove the lamp cover, release the retaining screws, pull the old module straight out, insert the new U3-810-LAMP until it seats firmly, re-tighten the screws, replace the cover, then reset the lamp timer in the menu — the timer reset is the step most often missed.

When will the U3-810-LAMP need to be replaced again, and what indicates end of life?

Replace the module when the projector's lamp-hour counter approaches the rated limit or when the image becomes noticeably dimmer and the lamp-warning LED illuminates; the included one-year warranty covers premature failure.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.