We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black rectangular PoE splitter with Ethernet and DC connectors

JacobsParts Inc.

JacobsParts POESPL-E 48V to 12V 2A 24W IEEE 802.3af Splitter

SKU CH-0CD9-RX8B8

Splits 48V PoE into 12V 2A 24W for IP cameras, phones or APs with 5.5×2.1mm DC plug and overvoltage protection

  • ColorBlack
  • CompatibilityInternet Protocol Camera

Option 1 pack

  • Powers non-PoE devices over Ethernet cables
  • IEEE 802.3af compliant with 12V 2A 24W output
  • 5x2.1mm DC plug fits most 12-volt gear
  • Plug-and-play install needs no configuration
  • Overvoltage protection guards connected equipment

Purpose and audience

The JacobsParts POESPL-E is a PoE splitter that converts 48 V input into 12 V at 2 A for 24 W output. It targets installers who need to power non-PoE IP cameras, VoIP phones or wireless access points over existing Ethernet cabling.

Suitability and limits

This unit suits deployments where the powered device accepts a 5.5 × 2.1 mm barrel connector and draws no more than the rated 24 W. It is not for equipment that requires higher voltage, greater current, a different connector polarity or passive PoE injection.

Installation checks

Verify that the network switch or injector supplies IEEE 802.3 af power on the Ethernet line. Confirm the target device operates on 12 V DC with a centre-positive 5.5 × 2.1 mm jack and that its maximum draw stays within 2 A.

Highlights

  • Powers non-PoE devices over Ethernet cables
  • IEEE 802.3af compliant with 12V 2A 24W output
  • 5x2.1mm DC plug fits most 12-volt gear
  • Plug-and-play install needs no configuration
  • Overvoltage protection guards connected equipment

Specifications

BrandJacobsParts
ModelPOESPL-E
ColorBlack
CompatibilityInternet Protocol Camera

Other versions of this model

5 more in the same range

Same family, different memory, cooler or clock — compare before you commit.

Questions about this item

What power source must already be available for the 48V to 12V 2A 24W IEEE 802.3af Splitter to operate?

It requires a Power over Ethernet source that supplies 48V and complies with the IEEE 802.3af standard, such as a PoE switch or a PoE injector.

Will the 5.5x2.1mm DC connector on the POESPL-E fit the 12V input on an older IP camera or wireless AP I already own?

The splitter provides a 5.5 mm outer diameter by 2.1 mm inner diameter barrel plug delivering 12V at up to 2A, which matches the common DC jack found on many legacy IP cameras, VoIP phones and access points.

How can I confirm the POESPL-E is delivering 12V and 24W to my device after I connect it?

Power the PoE source, plug the Ethernet cable into the splitter’s input and the DC barrel into your device; if the device powers on and operates normally, the splitter is converting the 48V PoE feed to the specified 12V 2A output.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.