We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten clear connectors with short wires linking RGB LED strips

JacobsParts Inc.

JacobsParts Inc. LSA-Y6-10PK 10mm 4-wire solderless flexible coupler straight blade plug 10-pack 15cm wire

SKU CH-M856-AX3RV MPN LSA-Y6-10PK

Connect two waterproof RGB LED strips with flexible 15 cm wire, punch-through design keeps silicone coating intact, pack of 10

  • ColorRGB
  • Item Count10
  • Materialvinyl, Silicone
  • TypeLED Light Strip Connector
  • FeaturesWaterproof
  • Number of Wires4
  • Solderless design connects waterproof RGB strips in seconds
  • Flexible 15 cm wire bridges gaps around corners
  • Bottom-piercing contacts keep silicone coating intact
  • Ten couplers per pack for multiple installations
  • Fits 10 mm 4-conductor 5050 RGB LED strips

10mm 4-wire solderless coupler 10-pack

This pack supplies ten 10mm four-wire solderless flexible couplers with 15cm leads for joining waterproof RGB LED strips. Installers and DIY enthusiasts use them to bridge cut sections without stripping the silicone coating. The punch-through design contacts the PCB from the underside, preserving the strip’s waterproof rating. Each connector accepts standard 5050 four-conductor PCB strips.

Replaces silicone-stripping and solder joints

Instead of scraping silicone off the strip and soldering wires, you open the connector tops, insert the strips and snap them shut. The jump is worth it whenever a layout demands flexible wire between segments — around corners, across gaps or through tight contours — and the waterproof seal must stay intact. It eliminates the time and heat risk of traditional soldering on coated strips.

Handles 10mm RGB strips with 15cm wire gaps

Each coupler comfortably spans a 15cm distance between two cut pieces of waterproof 10mm four-conductor strip. The flexible wire absorbs movement and vibration in automotive or marine installs. It runs out when the required gap exceeds the fixed 15cm lead length or when the strip width differs from 10mm. Builders needing longer runs or non-waterproof top-clip connectors must source different parts.

Highlights

  • Solderless design connects waterproof RGB strips in seconds
  • Flexible 15 cm wire bridges gaps around corners
  • Bottom-piercing contacts keep silicone coating intact
  • Ten couplers per pack for multiple installations
  • Fits 10 mm 4-conductor 5050 RGB LED strips

Specifications

BrandABI
ModelLSA-Y6-10PK
ColorRGB
Item Count10
Materialvinyl, Silicone
TypeLED Light Strip Connector
FeaturesWaterproof
Number of Wires4

Questions about this item

What size LED strip does the 10mm 4-wire coupler fit?

The connector fits waterproof 10mm 4-conductor PCB strips, typically 5050 RGB LED strips with a silicone coating.

How do I install the solderless coupler without damaging the strip?

Open the connector tops, insert each strip end so the pins punch through the silicone from the bottom, then close the tops to lock the connection without stripping the coating.

Will the 15 cm wire between the connectors need replacement over time?

The 15 cm flexible wire is permanently integrated; if a section fails, the whole coupler is replaced rather than the wire alone.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.