We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten white solderless couplers with short flexible wires and 2-pin plugs

JacobsParts Inc.

JacobsParts Inc. LSA-Y2-10PK 10x 8mm 2-wire solderless flexible coupler 15cm straight blade plug

SKU CH-BN83-Y0TE5 MPN LSA-Y2-10PK

Pack of ten solderless 8 mm two-wire couplers with 15 cm flexible leads for joining waterproof LED strips without removing silicone coating

  • Colorwhite
  • Item Count10
  • TypeLED Light Strip Connector
  • FeaturesWaterproof
  • Solderless design connects waterproof LED strips without tools
  • 15 cm flexible wire bridges gaps around corners and contours
  • Bottom-piercing contacts preserve silicone coating for lasting waterproof seal
  • Pack of 10 couplers covers multiple joint points in one purchase
  • Compatible with 8 mm 2-wire strips using 2835 or 3528 chips

10-pack solderless LED strip couplers

This pack contains ten 8mm two-wire flexible couplers for joining waterproof LED strip lights. Each coupler has a 15cm wire lead and a straight blade plug that punches through the silicone coating to contact the PCB. No soldering or coating removal is required. The connectors suit single-colour 2835 or 3528 strips.

Tool-free connection that maintains waterproofing

The coupler tops open to accept the strip ends, then close to lock the pins through the bottom of the PCB. This method preserves the strip’s original waterproof seal while allowing flexible routing around corners and contours. The 15cm wire between connectors gives enough slack for gentle bends without stressing the solder pads.

Low-profile design for discreet installations

The white housing blends with typical strip backings and adds minimal bulk to the run. Because the connection is made through the coating, the strip’s IP rating is not compromised during normal indoor or covered outdoor use. The two-pin layout carries power to single-colour strips without extra wiring complexity.

Highlights

  • Solderless design connects waterproof LED strips without tools
  • 15 cm flexible wire bridges gaps around corners and contours
  • Bottom-piercing contacts preserve silicone coating for lasting waterproof seal
  • Pack of 10 couplers covers multiple joint points in one purchase
  • Compatible with 8 mm 2-wire strips using 2835 or 3528 chips

Specifications

BrandJacobsParts
ModelLSA-Y2-10PK
Colorwhite
Item Count10
TypeLED Light Strip Connector
FeaturesWaterproof

Questions about this item

Do these couplers generate any heat or noise when the LED strip runs continuously?

The couplers are passive connectors with no electronics, so they produce no heat or noise during operation.

What must I already own to use these 8 mm 2-wire solderless flexible couplers?

You need waterproof 8 mm 2-conductor LED strip that uses single-colour SMD3528 chips and has a silicone coating.

Will the 15 cm wire on these couplers work with older 8 mm LED strips I already have installed?

Yes, provided the existing strips are waterproof 8 mm 2-conductor PCB types with silicone coating; the connectors punch through the coating without removing it.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.