We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Orange duplex multimode fibre patch cable with ST connectors, 2.0 m

Intellinet Network Solutions

Intellinet Network Solutions Duplex Multimode ST/ST 62.5/125 OM1 2.0 m Orange fibre optic cable

SKU CH-PEP2-T78N2

Duplex multimode OM1 patch cable with ST connectors, 2.0 m orange jacket for Gigabit Ethernet links

  • UPC connectors improve return loss for cleaner signals
  • Duplex multimode OM1 supports Gigabit Ethernet links
  • 5/125 µm core/cladding matches legacy infrastructure
  • 0 m (7.0 ft) length suits rack-to-panel runs
  • Orange jacket simplifies cable identification in dense trays

Duplex Multimode OM1 Patch Cable

This Intellinet Network Solutions cable is a duplex multimode fibre optic patch lead with ST/ST connectors and a 62.5/125 µm core/cladding diameter. It is rated OM1 and measures 2.0 m in length. The orange jacket identifies the multimode classification. It suits installers and network engineers who need a ready-made link for Gigabit Ethernet segments or other short-range multimode applications.

UPC Connectors for Sustained Return Loss

The cable uses Ultra Physical Contact connectors on both ends to maintain a better surface finish and improved return loss over time. Multimode fibre supports high bandwidth across the distances typical of campus or building backbones. Because the cable contains no metallic components, it remains unaffected by electromagnetic interference from utility lines, power lines or railway environments and is also suitable for areas with high lightning-strike incidence.

Simple ST Connector Installation

Each end terminates in an ST connector that twists to lock, so the patch cord can be seated without special tools. The 2.0 m length provides enough slack for rack-to-rack or wall-box connections while avoiding excess coil that could stress the ferrules. Care is needed to keep the ceramic end faces clean; contamination is the most common cause of elevated insertion loss on multimode links.

Highlights

  • UPC connectors improve return loss for cleaner signals
  • Duplex multimode OM1 supports Gigabit Ethernet links
  • 5/125 µm core/cladding matches legacy infrastructure
  • 0 m (7.0 ft) length suits rack-to-panel runs
  • Orange jacket simplifies cable identification in dense trays

Specifications

BrandIntellinet

Questions about this item

Does the 2.0 m orange cable generate any heat or noise when run continuously in a Gigabit Ethernet link?

No. The duplex multimode patch cord is a passive glass assembly with ST connectors; it draws no power and produces no heat or audible noise during continuous operation.

What equipment must already have ST ports to use this 62.5/125 µm OM1 patch lead?

Both ends require ST receptacles — typically multimode transceivers, media converters or switch modules that accept ST connectors on 62.5/125 µm fibre.

Will this OM1 ST/ST jumper work alongside legacy 62.5/125 µm cabling already installed in the building?

Yes. It matches the same 62.5/125 µm core/cladding dimensions and OM1 classification, so it can be spliced or patched into existing OM1 runs without mode mismatch.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.