We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Orange duplex fibre cable ten metres long with LC connectors on both ends

iMBAPrice

iMBAPrice 62.5/125 Multimode Duplex Fibre Optic Cable 10m LC-LC

SKU CH-JWHB-9Q2WG

A 10 metre duplex multimode fibre cable with LC connectors on both ends

  • 10 metre duplex link for extended low-latency runs
  • 5/125 multimode core supports high-bandwidth data transfer
  • LC-LC connectors enable quick patch-panel connections
  • Fibre construction eliminates electromagnetic interference
  • Duplex design provides simultaneous send and receive paths

What this cable is and who it fits

This iMBAPrice multimode duplex fibre optic jumper uses 62.5/125 micron fibre with LC-LC connectors at each end. It suits network installers and IT teams linking switches, transceivers or patch panels in campus and building backbones where multimode infrastructure already exists. The ten metre length covers typical rack-to-rack or cross-connect runs without excess slack. Buyers needing single-mode fibre or different connector types should select another product.

Thermals noise and power in normal use

Passive glass fibre carries light instead of electricity, so the cable generates no heat and draws zero power during operation. There are no active components, fans or electronics to create audible noise. The assembly is immune to electromagnetic and radio-frequency interference, preserving signal integrity alongside power cables or in electrically noisy plant rooms. Physical handling follows standard fibre bend-radius practice.

What this replaces and when the upgrade applies

The jumper replaces older 62.5/125 micron patch leads with worn ferrules, damaged jackets or mismatched connectors that increase insertion loss. It also upgrades links currently running on copper where distance or interference degrades throughput. The improvement is worthwhile when existing multimode equipment remains in service and a reliable low-latency path is required over the full ten metre span.

Highlights

  • 10 metre duplex link for extended low-latency runs
  • 5/125 multimode core supports high-bandwidth data transfer
  • LC-LC connectors enable quick patch-panel connections
  • Fibre construction eliminates electromagnetic interference
  • Duplex design provides simultaneous send and receive paths

Specifications

BrandiMBAPrice

Questions about this item

How is the LC-LC duplex jumper installed, and what step is often missed?

Insert each LC connector until the latch clicks; the common miss is leaving one end unlatched, which causes intermittent signal loss.

What maintenance or replacement will the 62.5/125 multimode fibre need over time?

Inspect and clean the LC ferrules with a fibre scope and click-to-clean tool whenever links are reconnected; replace the jumper if insertion loss exceeds your link budget.

What distance limit appears first on a 10 metre 62.5/125 multimode run under sustained use?

The 10 metre length stays well within the modal-bandwidth reach of 62.5/125 fibre for common Ethernet speeds, so connector contamination or bend loss will limit performance before fibre attenuation does.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.