We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Gray flanged receptacle with shrouded pins, IP67 rated

Hubbell Incorporated

Hubbell Incorporated HBL460R9W Watertight Pin & Sleeve Receptacle 60A

SKU CH-FCS1-PR08V

A 60 A, 250 V AC three-phase receptacle with IP67-rated Zytel 101 nylon housing, screw terminals for 8–2 AWG wire, and –40 °C to +75 °C operating range

  • Color/FinishGray
  • Color MappingBlue
  • TypeLight Switch
  • 60 A three-phase power for heavy-duty industrial loads
  • IP67 and NEMA 4X enclosure blocks water and dust ingress
  • Zytel 101 nylon body resists impact and chemical exposure
  • Screw terminals accept 8 to 2 AWG conductors for secure wiring
  • Certified to UL1682, CSA C22.2 and IEC standards

Industrial Three-Phase Receptacle

The Hubbell HBL460R9W is a 60 amp, 250 volt AC pin and sleeve receptacle built for three-phase industrial power distribution. It suits facilities that need a watertight connection point for heavy equipment or temporary power systems. The IEC grounding configuration and shrouded contacts support safe mating cycles in demanding environments.

Thermal and Environmental Performance

The device operates reliably from minus 40 degrees Celsius up to plus 75 degrees Celsius, maintaining its IP67 ingress protection and NEMA Type 4X rating across that range. A neoprene gasket and Zytel 101 nylon body resist moisture, impact and chemical exposure without active cooling or moving parts. Power dissipation stays within the limits implied by the 60 amp rating and UL94 HB flammability classification.

Construction and Wiring Practicalities

The flanged, straight-entry housing accepts conductors from 8 to 2 AWG secured by screw terminals, giving installers a straightforward termination method. Grey Zytel 101 nylon provides structural rigidity while the blue colour mapping identifies the voltage rating at a glance. Compliance with CSA C22.2 No.0.17 and No.182.1, UL1682 and IEC standards means the receptacle meets recognised industrial safety benchmarks for permanent or semi-permanent installation.

Highlights

  • 60 A three-phase power for heavy-duty industrial loads
  • IP67 and NEMA 4X enclosure blocks water and dust ingress
  • Zytel 101 nylon body resists impact and chemical exposure
  • Screw terminals accept 8 to 2 AWG conductors for secure wiring
  • Certified to UL1682, CSA C22.2 and IEC standards

Specifications

BrandHUBBELL
Color/FinishGray
Color MappingBlue
TypeLight Switch

Questions about this item

How do I wire the HBL460R9W receptacle and what step is often missed?

Strip the 8 to 2 AWG conductors, insert them into the screw terminals, and tighten each screw to the specified torque; the step most often missed is verifying the IEC grounding pin aligns with the shrouded contact before securing the flange.

What maintenance or replacement will this receptacle need over time?

Inspect the neoprene gasket and Zytel 101 nylon body for cracks or compression set after repeated mating cycles; replace the gasket if the IP67 seal is compromised, and replace the entire unit if the screw terminals show pitting or the housing is damaged.

What is the first limit reached under continuous three-phase load?

The 75 °C maximum operating temperature is the first limit; sustained 60 A at 250 V AC in a 40 °C ambient will bring the contacts to their thermal ceiling before the UL94 HB flammability rating or the IP67 enclosure become factors.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.