Hubbell Incorporated
Hubbell HBL560R7W IEC Pin and Sleeve Receptacle 60A 480V Red
Watertight IEC pin-and-sleeve receptacle rated 60 A, 277/480 V AC, IP67 and NEMA 4X with spring-loaded cap for industrial three-phase power
- Color/FinishRed
- Color MappingRed
- TypeLight Switch
- IEC 60 A 480 V industrial power connection
- IP67 and NEMA 4X watertight protection
- Spring-loaded cap seals out moisture and debris
- 10 hp motor rating for heavy-duty equipment
- Red thermoplastic housing for quick visual identification
Industrial Power Receptacle
The Hubbell HBL560R7W is a 60-amp IEC pin and sleeve receptacle rated for 277/480V AC three-phase power. It targets industrial facilities that need a watertight, grounded connection for heavy equipment such as 10 hp motors.
Flanged Mount with Spring Cap
A flanged housing and straight orientation let the unit bolt directly to a panel or enclosure without extra adapters. The spring-loaded cap seals the face to IP67 and NEMA 4X when the plug is removed, keeping water and debris out of the five-wire, four-pole interior.
Sustained Load Construction
Thermoplastic housing and shrouded contacts are built for continuous 60-amp service at 480 volts. The design accepts conductors up to 2 AWG, and the red housing provides quick visual identification in high-temperature, high-vibration environments.
Highlights
- IEC 60 A 480 V industrial power connection
- IP67 and NEMA 4X watertight protection
- Spring-loaded cap seals out moisture and debris
- 10 hp motor rating for heavy-duty equipment
- Red thermoplastic housing for quick visual identification
Specifications
| Brand | HUBBELL |
|---|---|
| Color/Finish | Red |
| Color Mapping | Red |
| Type | Light Switch |
Questions about this item
Will the 60 A rating hold under continuous three-phase load without overheating?
The receptacle is rated 60 A at 277/480 V AC with a 10 hp motor rating, so the 60 A limit is the thermal ceiling under sustained industrial use.
Does the IP67 thermoplastic housing stay cool and quiet during all-day operation?
The unit has no moving parts or fan, so it runs silently; the thermoplastic housing dissipates heat passively and the IP67 seal does not add audible noise.
What wiring and mounting hardware must I already have to install this flanged receptacle?
You need 5 conductors up to 2 AWG, a matching IEC 60 A 480 V plug, and a mounting surface drilled for the 4.15 in face diameter flange.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



