We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small rectangular SPI flash programmer board with USB connector and pin headers

Hetai Tech

Hetai Tech EZP2019 SPI FLASH Programmer Type 1 development board

SKU CH-D4T1-RJ5PQ

SPI flash programmer with USB 2.0 interface reaching 12 Mbps, reading EN25T80 in 3 seconds and writing in 9 seconds, auto-detecting chip model, placement and voltage, supporting 25, 24.

  • USB 2.0 interface reaches 12 Mbps transfer speed
  • Reads EN25T80 in 3 seconds and writes in 9 seconds
  • Automatic chip identification and voltage selection
  • Offline copy function works without a PC
  • Supports 25, 24, 93 series SPI and EEPROM chips

EZP2019 SPI flash programmer

The Hetai Tech EZP2019 is a USB 2.0 programmer for SPI flash and EEPROM chips. It reads an EN25T80 in 3 seconds and writes it in 9 seconds. Automatic chip identification, voltage selection and placement checks simplify the workflow. Firmware and PC software can be upgraded.

Replaces manual or slower programmers

The device upgrades from tools that require manual voltage setting or lack offline copy. The jump is worth it when you program 25, 24, 93 or 25 series chips regularly and need 12 Mbps throughput. It is not for users who only handle parallel flash or need gang programming.

Fits a laptop USB port for field service

The host connects by a shielded cable and draws power from the USB 2.0 port. Two unsoldered Easy Patch adapters are included for quick connections. The compact board suits bench repair and mobile BIOS recovery. Builders needing a regulated offline power board or extra sockets must choose a different type.

Highlights

  • USB 2.0 interface reaches 12 Mbps transfer speed
  • Reads EN25T80 in 3 seconds and writes in 9 seconds
  • Automatic chip identification and voltage selection
  • Offline copy function works without a PC
  • Supports 25, 24, 93 series SPI and EEPROM chips

Specifications

No published specifications for this item yet.

Questions about this item

Does the USB 2.0 interface on the EZP2019 Type 1 require a special driver or cable to reach 12Mbps?

The board uses a standard USB 2.0 connection and the package includes a high-speed shielded USB communication cable; no extra driver is mentioned for the 12Mbps rate.

What is the first step when installing the EZP2019 Type 1 programmer, and what common mistake should be avoided?

Connect the supplied shielded USB cable to the programmer and the PC, then launch the PC software; the step users often miss is confirming the chip is correctly seated before the software auto-detects it.

Which parts of the EZP2019 Type 1 kit are likely to wear out and need replacement after heavy use?

The two unsoldered Easy Patch Adapters and the USB cable are the only consumable items in the Type 1 package; the programmer host itself has no listed replaceable components.

New to this? Buying PC parts with Monero — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.