We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three black SATA cables with straight locking connectors, 15.75 inch length

HANNORD

HANNORD SATA Cable III 3 Pack 6Gbps 15.75 Inch Black

SKU CH-YTCH-HZKX0

Three SATA III cables with locking latches connect HDD, SSD and optical drives to motherboards at up to 6 Gbps over 15.75 inch length

  • ColorBlack
  • Up to 6 Gbps transfer speed with SATA 3.0 support
  • Locking latch on each end keeps connections secure
  • Three cables included for RAID setups or spare replacements
  • 75 inch length suits 2.5 and 3.5 inch drives
  • Low-profile jacket eases routing inside tight cases

Three-Pack SATA III Data Cables

This three-pack supplies straight SATA III cables with locking latches for connecting internal hard drives, solid-state drives and optical drives to a motherboard or host controller. Each cable measures 15.75 inches and carries a black low-profile jacket for easier routing inside the case. The cables handle data only; a separate power connection is required for every drive.

Replacing SATA I or II Cables

Swapping older SATA I or SATA II cables for these SATA III versions enables the 6 Gbps signalling rate where the drive and controller both support Revision 3.0. The upgrade is worthwhile when you install a modern SSD or HDD on a SATA III port and want to avoid the 3 Gbps ceiling of the previous revision. Existing SATA I and II devices remain fully compatible.

Check Port Orientation and Drive Power

Verify that your motherboard or controller presents standard 7-pin SATA ports with enough clearance for the straight connectors and locking clips. Confirm each target drive has its own SATA power connector from the power supply, because these cables carry data only. The 15.75-inch length suits typical mid-tower layouts; measure the routing path if your case is unusually large or uses a non-standard drive cage.

Highlights

  • Up to 6 Gbps transfer speed with SATA 3.0 support
  • Locking latch on each end keeps connections secure
  • Three cables included for RAID setups or spare replacements
  • 75 inch length suits 2.5 and 3.5 inch drives
  • Low-profile jacket eases routing inside tight cases

Specifications

ColorBlack

Questions about this item

What clearance do I need for the 15.75 inch cable and its low-profile jacket inside my case?

The cable is 15.75 inches long with a low-profile jacket designed for easier routing in tight spaces; measure the path from your motherboard SATA port to the drive bay to confirm it reaches without sharp bends.

How do I engage the locking latch correctly so the connection does not come loose?

Align the 7-pin L-type connector, push straight in until you feel a click, then verify the stainless-steel clip on each end has snapped over the port tab — do not force it at an angle or the latch may not seat.

How can I tell if a cable in the 3-pack has degraded and needs swapping out?

Inspect the 7-pin connectors for bent pins, cracked latch clips, or frayed jacket; if you see intermittent drive detection or CRC errors on a specific port, replace that cable first.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.