Hamzan
Hamzan 2-Pack 90W 12V USB Panel Mount Charger Dual 36W PD QC3.0 18W with 65W Cables
A two-pack of 12 V panel-mount chargers delivering 36 W per PD port and 18 W via QC 3.0 for 90 W total across three devices, supplied with 65 W USB-C cables
- TypeAutomobile Chargers
- Dual PD ports deliver 36W each for fast charging
- QC3.0 port adds 18W for simultaneous three-device power
- 90W total output charges laptops and phones together
- Panel-mount design installs with a small hole and 20AWG wiring
- Included 65W USB-C cables support full 36W PD performance
Dual-port 90W panel charger
This Hamzan 2-pack provides two 12 V panel-mount USB outlets rated at 90 W total. Each port delivers up to 36 W via Power Delivery while a Quick Charge 3.0 port adds 18 W. The set includes two 65 W USB-C cables so three devices can charge at once in a car, bus, RV or truck.
Thermals noise and 12 V draw
The charger operates from a 12 V vehicle supply and is designed for surface mounting on any flat panel with only a small wiring hole. A non-slip waterproof and dustproof switch stays closed by default and must be pressed again after the vehicle is turned off, limiting standby current and keeping the unit cool and silent during normal use.
Sustained three-device loading
When all three outputs are active the combined 90 W rating is maintained without reducing per-port speed, so a laptop, phone and tablet can charge together for extended periods. The 20 AWG supply wires connect to the vehicle’s positive and negative terminals and the screw terminals are tightened under the cover for a secure permanent installation.
Highlights
- Dual PD ports deliver 36W each for fast charging
- QC3.0 port adds 18W for simultaneous three-device power
- 90W total output charges laptops and phones together
- Panel-mount design installs with a small hole and 20AWG wiring
- Included 65W USB-C cables support full 36W PD performance
Specifications
| Type | Automobile Chargers |
|---|
Questions about this item
How do I wire the panel-mount charger into a 12 V system and which step is most often missed?
Connect the 20 AWG red wire to the + positive terminal and the black wire to the – negative terminal, drill a small hole for the wires, tighten the mounting screws, then snap the cover on; the step most often missed is pressing the non-slip switch again after the vehicle is turned off to re-enable output.
What part of the kit will need replacement first with regular use?
The included 65 W USB-C to USB-C cables are the wear items; repeated plugging and vibration in a vehicle can degrade the connectors or insulation, so plan to swap them out before the panel-mount sockets themselves.
What power limit appears first when three devices draw current continuously?
The 90 W total output ceiling is reached before any single port hits its 36 W PD maximum, so sustained triple-device charging will throttle at the combined 90 W limit.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



