Fervit XT60 to DC 5.5x2.5mm Angled Power Adapter

XT60 to DC 5.5×2.5 mm angled adapter

This adapter converts an XT60 male connector to a DC 5.5×2.5 mm male plug, allowing a TS100 soldering iron to draw power from a standard RC LiPo battery pack. The right-angled body keeps the cable close to the battery, reducing strain in tight battery compartments or field repair kits. It is aimed at FPV pilots, drone builders and hobbyists who need a quick, solder-free power link for portable soldering or other DC devices.

Sustained load behaviour

The connector pair is rated for high temperature resistance and good insulation, supporting continuous current flow during extended soldering sessions or prolonged FPV video transmitter operation. Plug-and-play construction means no intermediate wiring that could add resistance or heat, so voltage drop stays low as long as the source battery can deliver the required amperage. Users relying on small-capacity packs should monitor cell voltage to avoid deep discharge.

Build quality and daily use

The moulded housing uses heat-resistant plastic that withstands the warmth of a running soldering iron and outdoor flying conditions. The vertical angle lets the adapter seat fully into a female XT60 port even when surrounding frame plates or battery straps leave minimal clearance. No tools are needed for connection, making it practical for rapid field repairs, while the robust pins maintain a secure fit through repeated insertions. Not suited for applications that require a straight-through cable exit or a locking barrel connector.