We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Yellow XT60 male plug to black right-angled DC 5.5×2.1 mm male jack adapter

Fervit

Fervit XT60 Male to DC 5.5×2.1mm Male Angled Adapter

SKU CH-08Q4-1H8XD

Connects a TS100 soldering iron or FPV gear to an XT60 battery using an angled DC 5.5×2.1 mm plug for tight spaces

  • Powers TS100 soldering iron from XT60 batteries
  • Angled plug fits tight spaces around female ports
  • High-temperature materials resist heat during field repairs
  • Connects FPV drones, solar cells and RC toys
  • Plug-and-play design needs no extra tools or setup

XT60 to 5.5×2.1mm Angled Adapter

This adapter converts an XT60 battery output to a 5.5×2.1mm DC male plug. It is built for pilots and hobbyists who power a TS100 soldering iron or similar DC gear from a flight pack. The right-angle body lets the cable sit close to the chassis in tight frames. Field-repair kits benefit from the compact, plug-and-play format.

Practical limits of the XT60

The XT60 side handles up to 60 A continuous current, while the barrel side is rated for typical DC loads up to 100 W. Voltage passes straight through, so the connected device must tolerate the battery’s cell count. No regulation or protocol conversion occurs; the adapter simply bridges the two connector types. Polarity follows the XT60 source, so verify the DC device expects centre-positive wiring.

Build quality and daily implications

High-temperature resistant housing and insulated contacts survive soldering-iron heat and outdoor flying conditions. The angled moulding reduces strain on both the battery port and the device jack during vibration. Gold-plated pins resist corrosion from fuel residue or humidity. The snug friction fit stays secure without locking clips, yet releases easily for rapid battery swaps at the field.

Highlights

  • Powers TS100 soldering iron from XT60 batteries
  • Angled plug fits tight spaces around female ports
  • High-temperature materials resist heat during field repairs
  • Connects FPV drones, solar cells and RC toys
  • Plug-and-play design needs no extra tools or setup

Specifications

BrandFervit

Questions about this item

Should I choose the straight or the angled version of this XT60 to DC 5.5×2.1 mm adapter?

Only the angled version is offered; its vertical design lets the plug sit flush when space around the female port is tight.

What does the 60 A rating mean when I power a TS100 soldering iron from a LiPo pack?

The XT60 connector is rated for 60 A continuous current, so it can deliver the high amperage the TS100 draws without overheating the joint.

Does the DC 5.5×2.1 mm end follow a specific charging protocol that limits voltage or current?

No protocol is built into the adapter; it passes whatever voltage and current the connected battery supplies up to the XT60’s 60 A limit.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.