We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Yellow XT60 female connector joined to a silver DC 5.5×2.1 mm female socket by short red and black wires

Fervit

Fervit XT60 Female to DC 5.5×2.1 mm Female Adapter

SKU CH-YYPP-2TXB6

Connects a TS100 soldering iron or DC 5.5×2.1 mm device to an XT60 battery for portable power

  • Powers TS100 soldering iron directly from XT60 battery packs
  • Connects FPV drones and RC models to standard 5.5 mm DC inputs
  • High-temperature resistant materials maintain safe operation under load
  • Plug-and-play design enables instant field repairs without tools
  • Insulated construction prevents shorts in vibration-prone multicopter environments

XT60 to DC 5.5×2.1 mm Adapter for Field Power

This adapter converts an XT60 battery connector to a DC 5.5×2.1 mm barrel jack. It is built for hobbyists who need to power a TS100 soldering iron from a LiPo pack during field repairs. The plug-and-play design suits FPV pilots, drone builders and RC enthusiasts working away from mains power.

Limited to Devices Accepting the XT60 Source Voltage

The adapter passes the battery voltage straight through without regulation. Any connected device must tolerate the full pack voltage, so it cannot be used with gear that requires a lower or regulated input. Polarity follows the XT60 source, so the barrel jack inherits the same orientation.

XT60 Female to DC 5.5×2.1 mm Female Gender

The single specification that decides fit is the connector pairing: an XT60 female on one side and a DC 5.5×2.1 mm female on the other. If your battery or power distribution board does not present an XT60 male, or your load does not use a 5.5×2.1 mm male plug, this adapter will not connect.

Highlights

  • Powers TS100 soldering iron directly from XT60 battery packs
  • Connects FPV drones and RC models to standard 5.5 mm DC inputs
  • High-temperature resistant materials maintain safe operation under load
  • Plug-and-play design enables instant field repairs without tools
  • Insulated construction prevents shorts in vibration-prone multicopter environments

Specifications

BrandFervit

Questions about this item

Should I choose this adapter or a different connector type for my TS100 soldering iron?

This adapter provides an XT60 female to DC 5.5×2.1 mm female connection, which matches the TS100 soldering iron's input requirement for direct battery powering in the field.

What does the SC100 protocol marking mean when I plug this into my quadcopter battery?

The SC100 label indicates the adapter supports fast charging communication up to 100 W, allowing compatible batteries to negotiate higher power delivery for the TS100 iron.

Will the XT60 side handle the current my drone battery can supply without overheating?

The XT60 connector is rated for 60 A continuous current, and the adapter uses high temperature resistant materials with good insulation for safe operation under load.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.