We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short .5m SFF8654 8i to dual SFF8087 breakout cable with slim connectors

Fervit

Fervit SFF8654 8i to 2×SFF8087 SAS breakout cable .5m

SKU CH-PZAK-8CZXD

Converts one SFF8654 8i port into two SFF8087 SAS ports for multidrive storage expansion in compact servers

  • Low-profile slim design fits compact high-density server and workstation chassis
  • 1-to-2 breakout converts single SFF8654 8i port to dual SFF8087 SAS ports for multi-drive storage expansion
  • 30AWG low-loss pure copper wire ensures stable 12Gbps high-bandwidth data transfer for SAS HDDs, SSDs and RAID controllers
  • Precision-shielded harness minimises signal crosstalk and attenuation for long-term enterprise-grade reliability
  • 5m short length enables clean internal routing inside small-form-factor rack servers and compact workstations

Internal SAS breakout for dense chassis

This Fervit cable converts a single SFF8654 8i port into two SFF8087 connectors. The low-profile design fits space-restricted high-density server and workstation chassis. It targets administrators expanding multi-drive storage inside compact rack systems. Builders needing longer reach or different port types should look elsewhere.

Passive copper harness runs cool and silent

The 30AWG pure copper wires carry 12Gbps signals without active components. No fan or heatsink is required, so the assembly adds zero noise and negligible heat. Precision shielding limits crosstalk and attenuation across the short run. Power draw is limited to the attached drives and controller.

Steady 12Gbps throughput under sustained load

Shielded 30AWG conductors maintain signal integrity during continuous RAID rebuilds or bulk transfers. The 0.5 metre length keeps latency low and routing tidy in small-form-factor enclosures. Enterprise-grade reliability is supported by the low-loss construction. Performance scales with the connected SAS HDDs, SSDs and RAID controllers.

Highlights

  • Low-profile slim design fits compact high-density server and workstation chassis
  • 1-to-2 breakout converts single SFF8654 8i port to dual SFF8087 SAS ports for multi-drive storage expansion
  • 30AWG low-loss pure copper wire ensures stable 12Gbps high-bandwidth data transfer for SAS HDDs, SSDs and RAID controllers
  • Precision-shielded harness minimises signal crosstalk and attenuation for long-term enterprise-grade reliability
  • 5m short length enables clean internal routing inside small-form-factor rack servers and compact workstations

Specifications

BrandFervit

Questions about this item

How do I install the SFF8654 8i to 2×SFF8087 breakout cable in a low-profile server chassis?

Align the SFF8654 8i connector with the controller port, press straight in until the latch clicks, then route the 0.5 m harness to each SFF8087 backplane connector; the slim 30 AWG wires bend easily but avoid sharp folds that could damage the copper cores.

What maintenance or replacement will the cable need after extended use in a high-density rack?

Inspect the latch tabs and shielding for dust or deformation during scheduled server shutdowns; if a tab snaps or crosstalk appears in SMART logs, replace the harness — the 30 AWG pure copper conductors are not field-repairable.

What is the first limit that appears when the cable runs sustained 12 Gbps SAS traffic?

The 0.5 m length and 30 AWG gauge set the practical ceiling; signal attenuation stays within spec for 12 Gbps, but any longer run or tighter bend radius would degrade eye-diagram margin first.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.