We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Low-profile SFF-8654 LP 74-pin breakout cable to eight SATA connectors, .5 m length

Fervit

Fervit 0.5M SFF-8654 LP 8i 74Pin to 8×SATA Cable 30AWG 100 Ohm

SKU CH-Y8MV-1T13H

Low-profile breakout cable splits a SFF-8654 LP 74-pin host port into eight SATA connections using 30AWG copper with 100 Ohm impedance for stable high-speed data transmission in compact servers

  • Converts one SFF-8654 LP 74-pin port into eight SATA drives for multi-drive expansion
  • 100 Ohm impedance matching maintains stable signal integrity for high-speed SAS transmission
  • Premium 30 AWG low-loss copper wire minimises signal attenuation and crosstalk
  • Low-profile design fits compact slim servers and space-restricted OEM rackmount systems
  • 5 M short optimised length supports clean internal routing for RAID controllers and storage backplanes

Fervit SFF-8654 LP 8i Breakout Cable

This new cable converts a single SFF-8654 LP 74-pin host port into eight independent SATA ports for multi-drive expansion. It is built for administrators and integrators adding high-density storage to compact servers or rackmount systems. The low-profile design suits space-restricted OEM chassis where standard connectors cannot fit.

Sustained Signal Integrity Under Load

Premium 30AWG low-loss copper wire minimizes attenuation and crosstalk during continuous high-speed PCIe and SAS transmission. The 100 Ohm impedance matching maintains stable signal integrity across all eight lanes without degradation over time. The short .5M length further reduces latency and signal loss in dense internal routing.

Installation In Tight Spaces

The low-profile connector allows the cable to seat cleanly in slim servers and spacerestricted backplanes without blocking adjacent slots. Routing is straightforward because the short optimised length leaves minimal slack to manage. Installers must verify the host port is an 8-lane SFF-8654 LP interface; a 4-lane or standard-height port will not accept this connector.

Highlights

  • Converts one SFF-8654 LP 74-pin port into eight SATA drives for multi-drive expansion
  • 100 Ohm impedance matching maintains stable signal integrity for high-speed SAS transmission
  • Premium 30 AWG low-loss copper wire minimises signal attenuation and crosstalk
  • Low-profile design fits compact slim servers and space-restricted OEM rackmount systems
  • 5 M short optimised length supports clean internal routing for RAID controllers and storage backplanes

Specifications

BrandFervit

Questions about this item

Does the 0.5M cable generate noticeable heat or need active cooling when running all day?

The 30AWG copper conductors and 100 Ohm impedance keep signal loss low, so the cable itself produces negligible heat and requires no active cooling.

What host connector must my system already have for this breakout to work?

Your controller or backplane needs a single SFF-8654 LP 8i 74Pin port to plug the low-profile end into.

Will the eight SATA plugs work with older 3 Gbps SATA drives I want to keep?

Yes, each SATA connector is backward compatible with earlier SATA revisions, so legacy drives will operate at their native speed.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.