We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Fervit MCIO SFF-8654 8i to eight SATA 7-pin female straight cable .5M 32AWG 85 Ohm

Fervit

Fervit 0.5M MCIO SFF-8654 8i to 8×SATA 7P Cable 32AWG 85 Ohm

SKU CH-VXZQ-X8792

Converts one MCIO SFF-8654 8i port to eight straight SATA 7-pin ports using .5 m, 32 AWG, 85 Ohm cable

  • Splits one MCIO SFF-8654 8i port into eight SATA drives
  • 85 ohm impedance matching preserves signal integrity at high speeds
  • 32AWG low-loss copper wire reduces attenuation and crosstalk
  • Straight SATA female connectors enable plug-and-play installation
  • .5 m length optimises routing in compact rackmount servers

High-density MCIO to SATA cable

This Fervit cable converts a single MCIO SFF-8654 8-lane PCIe or SAS host port into eight straight SATA 7-pin female connectors. It is built with 32AWG low-loss copper wire and 85 ohm impedance matching for stable signal integrity. The .5 metre length suits compact rackmount servers, RAID controllers and storage backplanes.

Suited for multi-drive server builds

Installers adding up to eight SATA drives to a single high-density host port will find this cable a direct fit. It is not for systems lacking an MCIO SFF-8654 8i interface, nor for builds that require right-angle SATA connectors or longer cable runs for full-tower routing.

Simple plug-and-play installation

Straight female SATA ends seat securely into drive backplanes or controller ports without tools. The short .5 metre length reduces slack but demands careful measurement; insufficient reach is the most common issue if the host port sits far from the drive cage.

Highlights

  • Splits one MCIO SFF-8654 8i port into eight SATA drives
  • 85 ohm impedance matching preserves signal integrity at high speeds
  • 32AWG low-loss copper wire reduces attenuation and crosstalk
  • Straight SATA female connectors enable plug-and-play installation
  • .5 m length optimises routing in compact rackmount servers

Specifications

BrandFervit

Questions about this item

Do I need a free MCIO SFF-8654 8i port on my RAID controller or motherboard to use this cable?

Yes, the cable plugs into a single MCIO SFF-8654 8-lane PCIe/SAS host port and breaks it out to eight SATA 7-pin female connectors.

Will the eight SATA ports on this cable work with my existing 6 Gb/s SATA hard drives and SSDs?

The SATA 7-pin female connectors are standard straight ports, so any SATA drive using that interface will connect directly.

How can I verify the 85 ohm impedance is holding up after I route the 0.5 m cable in my server?

With the drives detected at full link speed and no errors reported by the RAID controller or OS, the impedance matching is functioning correctly.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.