Fans
Fans case fan 120 mm 15 LED 12 V 3Pin 4Pin 25 mm
A 120 mm case fan with 15 LEDs, dual 3-pin and 4-pin connectors, and 25 mm thickness for 12 V cooling
- 15 LED lights for visible case illumination
- 12 V DC power from standard motherboard headers
- Dual 3-pin and 4-pin connectors fit most boards
- 120 mm by 25 mm size matches common mounts
120 mm case fan with dual connectors
This 120 mm case fan includes 15 LED lights and supports both 3-pin and 4-pin power connections. It fits standard 120 mm mounting points and runs on 12 V DC power. The unit is sold new for chassis or radiator cooling.
Thermals noise and power draw
The fan operates from a 12 V supply through either a 3-pin or 4-pin header, allowing speed control where supported. Its 25 mm frame houses the LED array and moving parts. Noise level and airflow depend on the voltage or PWM curve applied by the motherboard.
Highlights
- 15 LED lights for visible case illumination
- 12 V DC power from standard motherboard headers
- Dual 3-pin and 4-pin connectors fit most boards
- 120 mm by 25 mm size matches common mounts
Specifications
No published specifications for this item yet.
Questions about this item
How do I install the 120 mm case fan with both 3-pin and 4-pin connectors?
Align the four screw holes on the 120 mm frame with your case or radiator mounts, then secure with screws. Connect only one power header — either the 3-pin or the 4-pin plug — to the motherboard or fan controller; leaving both connected can cause signal conflict.
What maintenance will the 15 LED fan need over time?
Dust builds up on the blades and inside the 25 mm thick housing, so clean with compressed air every few months. The 12 V DC motor uses sleeve bearings that may eventually develop noise; if that happens, replace the entire fan unit.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



