Innovation First, Inc. 1UCMA-137 1U Cable Management Arm 19" 28.5"-33" computer accessory
- Product Type:Cable…
- Panel Width:19" Rac…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
ETopSell
A 75 ft unshielded Cat6 patch cable rated for 550 MHz bandwidth and gigabit Ethernet speeds
This 75 ft Cat6 UTP patch cord uses four solid conductors to carry 10/100/1000 Mbps Ethernet to IP cameras, switches, routers and other network devices. The black jacket suits permanent indoor routes through walls, ceilings or conduit where a factory-terminated lead saves termination time. It meets TIA/EIA-568-B-2.1 draft 9 requirements for structured cabling.
The unshielded twisted-pair design has no active components, so it draws no power and produces no noise during operation. Rated bandwidth of 550 MHz supports Gigabit Ethernet and 10GBase-T over the full 75 ft length. Solid conductors reduce insertion loss compared with stranded patch leads on runs of this distance.
Upgrading from a Cat5e or shorter Cat6 cord is worthwhile when the link must span 75 ft at Gigabit or 10 Gigabit speeds without intermediate switches. The solid-core construction is not suited for frequent flexing or patch-panel cross-connects that demand stranded cable. Buyers needing shielded cable for noisy environments should look elsewhere.
| Cat | 6 |
|---|---|
| Connector A | RJ45 |
| Connector B | RJ45 |
| Length | 75 ft. |
| Color | Black |
| Shielded | No |
| Features | Enhanced 550Mhz bandwidth for high-speed Data\Audio\Video and handle other intensive applications bandwidth. Cat6 - 4 Solid UTP (Unshielded Twisted Pair) Meets all Cat6 TIA/EIA-568-B-2.1, draft 9 standards Certified Transfer Rate: 10/100/1000 mbps (1000Base-T Gigabit) Best for use with 10/100Base-T, 1000Base-T and 10GBase-T high speed Ethernet network installation Molded booted ends with strain relieves for reliability. Gold plated connectors to insure a clean and clear transmission. Connector(s): RJ-45 - male. Type: Patch cable. |
Route the cable gently, avoiding sharp bends, and keep the four solid twisted pairs untwisted for no more than the minimum length needed at each RJ45 termination.
Inspect the RJ45 connectors for bent pins or cracked boots and replace the cable if the jacket shows cuts, kinks, or permanent deformation from pulling.
The 550 MHz bandwidth rating and 75 ft length set the practical ceiling before signal degradation affects the 1000 Mbps certified transfer rate.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?