We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short 8-inch Y-cable splitting a 4-pin Molex connector into a 3.5-inch floppy power plug

ETopSell

ETopSell 4375 8" 4-pin Molex to 3.5" floppy power splitter cord

SKU CH-VBE6-GJ5Z9

Adds a 3.5" floppy power connector by splitting an existing 4-pin Molex lead

  • Adds a 3.5 floppy power connector from a Molex source
  • Y splitter design provides one extra FDD plug without replacing the PSU
  • 8 inch cable length fits tight case routing
  • Model 4375 built for standard 4 pin Molex to floppy conversion
  • New condition ensures reliable power delivery to legacy drives

4-pin Molex to 3.5" floppy power splitter

The ETopSell 4375 is an 8-inch Y-cable that converts a single standard 4-pin Molex connector into an additional 4-pin floppy drive power connector. It is designed for users who need to add a 3.5-inch floppy drive or compatible device without replacing the power supply unit.

Suits legacy builds needing extra FDD power

This splitter suits builders working with older systems that still use 3.5-inch floppy drives and have a spare Molex lead available. It is not for systems that lack a free 4-pin Molex connector or for installations where the fixed short length cannot reach the drive mounting position.

8-inch fixed cable length

The cable measures 8 inches from end to end, which determines whether it can bridge the gap between your power supply's Molex output and the floppy drive's power input. Measure your chassis routing before purchase to confirm the reach is sufficient for your specific layout.

Highlights

  • Adds a 3.5 floppy power connector from a Molex source
  • Y splitter design provides one extra FDD plug without replacing the PSU
  • 8 inch cable length fits tight case routing
  • Model 4375 built for standard 4 pin Molex to floppy conversion
  • New condition ensures reliable power delivery to legacy drives

Specifications

BrandOEM
Model4375

Questions about this item

Will the 8-inch length reach from a Molex connector to a 3.5-inch floppy drive in a standard tower?

The cable is 8 inches long, so measure the distance between your PSU Molex output and the floppy bay before buying.

Which way round do the Molex and floppy connectors go, and what is the common mistake?

Plug the single Molex end into the PSU and the two floppy ends into drives; forcing a connector upside-down bends pins.

When should the splitter be replaced if the floppy drive loses power intermittently?

Replace the cord if the Molex or floppy pins feel loose, show discoloration, or the drive cuts out when the case vibrates.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.