EN-Labs
EN-Labs SATA3-RIGHT-50CM SATA cable 0.5 m right 90° to 180° red
A 0.5 m SATA III data cable with a right-angled 90° connector to a straight 180° latched connector, supporting 6 Gbps speeds
- TypeSATA III
- Length16" - 20"
- Cable Length1.64 ft. (0.50m)
- Connector Number2
- Connector Detail1 x SATA to 1 x SATA
- Terminal GenderFemale to Female
- Right-angled connector eases routing in cramped cases
- Latching straight end secures the link against vibration
- 6 Gbps SATA III bandwidth handles modern SSD speeds
- 26 AWG tinned copper conductors reduce signal loss
- Half-metre length keeps cable clutter to a minimum
Right-angled SATA cable for tight builds
This 0.5 m SATA III cable has one right-angled 90° connector and one straight 180° connector with a latch. The 26 AWG tinned copper conductors are shielded and support up to 6.0 Gbps transfer rates. The red jacket makes it easy to trace inside a crowded chassis.
Installers needing a single short run.
Builders routing a single drive behind a motherboard tray or into a cramped drive cage will appreciate the low-profile right angle. Anyone daisy-chaining several devices or running cables longer than .5 m should look at something else.
90° right-angled connector orientation
The defining spec is the right-side 90° to 180° connector pairing, which determines whether the cable clears adjacent headers or drive bays. Match this orientation to your board layout before ordering.
Highlights
- Right-angled connector eases routing in cramped cases
- Latching straight end secures the link against vibration
- 6 Gbps SATA III bandwidth handles modern SSD speeds
- 26 AWG tinned copper conductors reduce signal loss
- Half-metre length keeps cable clutter to a minimum
Specifications
| Brand | En-Labs |
|---|---|
| Model | SATA3-RIGHT-50CM |
| Type | SATA III |
| Length | 16" - 20" |
| Cable Length | 1.64 ft. (0.50m) |
| Connector Number | 2 |
| Connector Detail | 1 x SATA to 1 x SATA |
| Terminal Gender | Female to Female |
| Specifications | - Connector : 7-pin SATA right side-angled 90 degree to 180 Degree latching Receptacle "L" Type key connector - Supports SATA revision III up to 6 Gbps - Backwards compatible with SATA I, II ports - Cable length is 0.5 meter (19.7 inches) - 26AWG tinned copper conductors |
| Shielding | Yes |
| Conductor | Copper Conductor |
| Features | The SATA right side-angled 90 Degree to 180 Degree SATA III 6 Gbps Cable connects both newer SATA III and legacy SATA I, II drives to internal motherboards and host controllers. The straight connector has a latch to provide a secure connection in tight spaces. IT technicians always need a spare on hand as a troubleshooting tool. DIY gamers can quickly upgrade their computer for expanded storage. It is backed by a lifetime warranty and product support. |
Questions about this item
Does the 0.5 m length reach my drive?
The cable is 0.5 m (19.7 in) long; measure from your motherboard port to the drive bay to confirm it fits.
Will 6 Gb/s actually move data at that rate?
The link supports up to 6.0 Gb/s, but real throughput is limited by the slowest connected device — drive, controller or port.
What does the right-side 90° to 180° angle mean for my build?
One plug bends 90° to the right and the other runs straight (180°), letting you route the cable tight against a drive or motherboard edge.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00115201BTC
In stock
