We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 2ft SATA cable with straight and 90-degree latched connectors

EN-Labs

EN-Labs SATA cable 2ft 180 to 90 degree latch Black

SKU CH-X7RV-Y2BV6

SATA III data cable with 180-degree to 90-degree latching connectors, 24-inch length, 6.0 Gbps speed

  • TypeSATA 3
  • Length2ft
  • Cable Length2 ft.
  • Connector Number2
  • Up to 6 Gb/s throughput with SATA 3.0 specification
  • Works with SATA 1.5 Gb/s and 3 Gb/s legacy devices
  • 180-to-90-degree connectors fit tight spaces inside cases
  • Latching ends lock securely to host and drive ports
  • 24-inch 26 AWG tinned copper cable rated UL and RoHS

Straight-to-right-angle SATA cable

The EN-Labs SATA III cable connects a straight host port to a 90-degree device port using locking latches on both ends. It supports 6.0 Gb/s throughput and remains compatible with 1.5 and 3.0 Gb/s devices. The 24-inch length suits typical internal drive-to-motherboard runs. Black 26 AWG tinned-copper conductors carry the signal.

Sustained 6 Gb/s signalling

The cable is rated for the full SATA 3.0 6.0 Gb/s specification rather than a burst-only figure. Backwards compatibility with 1.5 and 3.0 Gb/s links means the same cable works across older and newer drives without speed negotiation issues. UL listing and RoHS compliance indicate the materials meet baseline safety and substance restrictions for continuous operation. EMI protection is noted for both internal and external routing.

Latch installation and routing

Each connector carries a locking latch that clicks onto standard Type L ports to resist vibration disconnects. The 180-to-90-degree geometry routes the cable parallel to the drive edge, reducing bend stress in tight drive cages. Installers should verify the 90-degree orientation matches the drive port direction before seating the latch; forcing the wrong angle can damage the port. The 24-inch span limits reach in full-tower layouts where the motherboard SATA cluster sits far from lower drive bays.

Highlights

  • Up to 6 Gb/s throughput with SATA 3.0 specification
  • Works with SATA 1.5 Gb/s and 3 Gb/s legacy devices
  • 180-to-90-degree connectors fit tight spaces inside cases
  • Latching ends lock securely to host and drive ports
  • 24-inch 26 AWG tinned copper cable rated UL and RoHS

Specifications

TypeSATA 3
Length2ft
Cable Length2 ft.
Connector Number2

Questions about this item

Does the 6.0 Gbps SATA III cable add noticeable heat or power draw when the drive runs all day?

The cable itself is passive and draws no power; heat comes only from the connected drive, not from the 24-inch 26 AWG tinned copper conductors.

What must my motherboard or drive already provide for this 180-to-90-degree latch cable to work?

Both ends need a standard SATA Type L data port; the cable supplies the straight and right-angle connectors with locking latches.

Will this 6.0 Gbps cable slow down an older 1.5 or 3.0 Gbps SATA drive I keep using?

It is backwards compatible with SATA 1.5 Gbps and 3.0 Gbps devices, so the older drive runs at its native speed without bottleneck.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.