Innovation First, Inc. 1UCMA-137 1U Cable Management Arm 19" 28.5"-33" computer accessory
- Product Type:Cable…
- Panel Width:19" Rac…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
EN-Labs
Extends a PCIe x1 slot to x16 with a 60cm USB 3.0 cable and Molex power, adding three solid capacitors, voltage regulation and overcurrent protection for stable GPU mining
This riser cable adapts a PCIe x1 motherboard slot to accept a full-length x16 graphics card. A 60cm USB 3.0 cable gives installers freedom to position the GPU away from the board. The kit targets builders assembling open-air mining rigs or compact systems where direct slot mounting is impractical.
The supplier notes that the graphics card may not be identified unless the motherboard BIOS is set to PCIe Gen 2 or Gen 1. Running the link at Gen 3 speeds is not supported by this cable, so bandwidth-sensitive workloads will operate at reduced throughput compared with a native x16 slot.
Three solid capacitors and on-board voltage regulation feed the card through a Molex 4-pin connector, pulling current from the power supply instead of the motherboard slot. This reduces strain on the board’s power delivery but requires a free Molex lead from the PSU; systems without spare Molex connectors cannot use the riser without an adapter.
| Type | PCIe Riser Cable |
|---|---|
| Features | 3 High Quality Solid Capacitors, Voltage Regulation, and Overcurrent Protection. 60cm USB 3.0 riser cable enabling flexibility in the placement of your PCI-E devices. Molex 4 PIN interface allows card to run off of separate power rails independent from motherboard effectively reducing power strain on motherboard Version 008S riser kits are the perfect solution for setting up Ethereum mining rigs (or any other GPU-mined altcoin), whether small open air rigs or large rack based miners. Compatible with 1x, 4x, 8x,16x PCI-E motherboard slots for ethereum mining Note: Please set BIOS PCIe |
The adapter plugs into any 1x, 4x, 8x or 16x motherboard slot and routes the connection through a 60cm USB 3.0 cable, so you simply match the slot you have available.
The card negotiates at x1 electrical width, so bandwidth is limited to a single lane; set the BIOS to Gen 2 or Gen 1 if the GPU is not detected.
It draws auxiliary power directly from the PSU, reducing load on the motherboard slot and providing voltage regulation with three solid capacitors and overcurrent protection.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?