We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White metal GPU brace with adjustable support arm and ARGB light strip, mounted on three PCI brackets

EN-Labs

EN-Labs GPU Brace Support with ARGB Strip and Controller, White

SKU CH-8GKR-B8P66

Adjustable metal brace prevents graphics card sag and includes a SATA-powered ARGB strip with a standalone controller for systems lacking a motherboard 5 V header

  • Prevents GPU sag with sturdy iron construction and adjustable slide support
  • 2-way length and height adjustment fits various graphics cards and cases
  • Built-in 5V 3-pin ARGB strip with dedicated SATA-powered controller
  • Controller offers manual mode, speed, colour and brightness buttons — no motherboard header required
  • Optional motherboard 5V 3-pin ARGB sync when controller is bypassed

GPU Sag Prevention for Heavy Cards

This adjustable bracket stops graphics cards from bending under their own weight over time. It suits builders who want structural protection without relying on case-specific props or makeshift supports. The white finish and integrated ARGB strip suit clean or themed builds alike.

Three-Slot PCI Mount with SATA-Powered ARGB

Installation requires three full-profile PCI expansion slots at the rear of the chassis. The brace draws power from a standard SATA connector, so no motherboard ARGB header is necessary. An included controller handles all lighting effects independently, freeing up board headers and simplifying cable routing.

Length and Height Adjustability for Most Cards

A two-way slide mechanism adapts to different card lengths and support heights, covering common dual- and triple-slot models. It cannot fit cases that lack three adjacent rear slots or builds where the card backplate sits too low for the support arm to reach. Extreme-length cards beyond the slider travel may need a different solution.

Highlights

  • Prevents GPU sag with sturdy iron construction and adjustable slide support
  • 2-way length and height adjustment fits various graphics cards and cases
  • Built-in 5V 3-pin ARGB strip with dedicated SATA-powered controller
  • Controller offers manual mode, speed, colour and brightness buttons — no motherboard header required
  • Optional motherboard 5V 3-pin ARGB sync when controller is bypassed

Specifications

No published specifications for this item yet.

Questions about this item

Will the three full-profile PCI slots required for mounting limit how many other expansion cards I can install?

The brace occupies three full-profile PCI slots on the rear of the case, so any other add-in cards must fit in the remaining slots available on your motherboard and chassis.

Does the included SATA-powered ARGB controller add noticeable heat or fan noise when the system runs all day?

The controller draws power from a standard SATA connector and runs passively; it produces no fan noise and only minimal heat during continuous operation.

What power connection must my power supply already provide for the ARGB lighting to work?

A spare SATA power connector from the power supply is required to run the built-in ARGB controller and light strip.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.