We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Transparent acrylic GPU support brace with magnetic base, adjustable height 1.38 to 6.77 inches

EN-Labs

EN-Labs ARGB GPU Brace 1.38"–6.77" Adjustable Acrylic Support

SKU CH-7PSE-7TQY0

Adjustable ARGB graphics-card support from 1.38 to 6.77 inches with magnetic base and 5 V 3-pin sync

  • Prevents GPU sag by supporting heavy graphics cards
  • Adjustable height from 1.38 to 6.77 inches fits ITX, MATX and ATX cases
  • 5V 3-pin ARGB sync with motherboard or controller for customisable lighting
  • 6 mm transparent acrylic shell enhances ARGB effects
  • Magnetic base allows tool-free, stable installation inside the chassis

ARGB GPU Brace with Adjustable Height

The EN-Labs ARGB GPU Brace supports heavy graphics cards to prevent sag and protect the motherboard slot. It adjusts from 1.38" to 6.77" to fit ITX, MATX and ATX chassis. A 6 mm transparent acrylic shell diffuses addressable RGB lighting for a clean look.

Passive Cooling and Silent Operation

The brace has no fans or moving parts, so it adds zero noise to the system. It draws power only for the 5 V 3-pin ARGB LEDs, which consume minimal current from the motherboard or controller. Thermals are unaffected because the accessory does not obstruct airflow around the card.

Magnetic Base for Tool-Free Installation

A strong hidden magnet in the metal base secures the bracket to the case floor without screws. The 5 V 3-pin ARGB header connects to a compatible motherboard or dedicated controller for synchronised lighting. The acrylic support frame keeps the card level while leaving surrounding expansion slots free.

Highlights

  • Prevents GPU sag by supporting heavy graphics cards
  • Adjustable height from 1.38 to 6.77 inches fits ITX, MATX and ATX cases
  • 5V 3-pin ARGB sync with motherboard or controller for customisable lighting
  • 6 mm transparent acrylic shell enhances ARGB effects
  • Magnetic base allows tool-free, stable installation inside the chassis

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the EN-Labs ARGB GPU brace and what is the step people often miss?

Place the magnetic base on the case floor, extend the acrylic arm to match your card height, and connect the 5V 3-pin ARGB cable to the motherboard header — many forget the ARGB connection and lose lighting sync.

What maintenance or replacement will the EN-Labs ARGB GPU brace need over time?

The acrylic arm and magnetic base are solid-state with no moving parts; only the 5V 3-pin ARGB cable or motherboard header may need reseating if lighting flickers after transport.

What is the first limit that appears when the EN-Labs ARGB GPU brace is used continuously under a heavy card?

The adjustable range tops out at 6.77 inches, so cards taller than that cannot be supported; the magnetic hold and acrylic stiffness remain constant during sustained use.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.