We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten PCIe riser cards with 60cm USB 3.0 cables and Molex power connectors

EN-Labs

EN-Labs 10-Pack PCIe 1X to 16X Riser Cable 2ft USB 3.0 Molex 4pin Powered internal power cable

SKU CH-D0ME-M4S3X

Ten PCIe 1X to 16X riser cards with 60 cm USB 3.0 cables and Molex power for GPU mining rigs

  • TypeRiser Cable
  • Length2FT
  • Cable Length2 ft.
  • Specifications3 High Quality Solid Capacitors, Voltage Regulation, and Ove
  • 10 riser cards per pack simplify multi-GPU builds
  • 3 solid capacitors with voltage regulation and overcurrent protection
  • 60 cm USB 3.0 cable allows flexible GPU placement
  • Molex 4-pin power reduces load on the motherboard
  • Compatible with 1x, 4x, 8x and 16x PCI-E slots

10-Pack PCIe 1X to 16X Riser Kit

This 10-pack supplies ten riser cards that convert a single PCIe lane into a full-length slot. Each unit includes a 60 cm USB 3.0 cable, three solid capacitors, and a Molex 4-pin power connector. The kit targets builders assembling multi-GPU mining rigs or expanding PCIe device capacity in open-air frames.

Gen 2 or Gen 1 BIOS limit

The USB 3.0 link cannot sustain Gen 3 signalling, so the motherboard BIOS must be set to Gen 2 or Gen 1 when a graphics card is not detected. Bandwidth above Gen 2 is not supported by the cable assembly. The riser fits 1x, 4x, 8x, and 16x motherboard slots but will not deliver full Gen 3 throughput to the attached device.

Simple install with BIOS step

Installation requires plugging the riser into the motherboard slot, connecting the Molex power, and attaching the GPU to the riser board. The most common issue is a missing device in BIOS, which is resolved by lowering the slot speed to Gen 2 or Gen 1. No drivers or additional software are needed for the riser itself.

Highlights

  • 10 riser cards per pack simplify multi-GPU builds
  • 3 solid capacitors with voltage regulation and overcurrent protection
  • 60 cm USB 3.0 cable allows flexible GPU placement
  • Molex 4-pin power reduces load on the motherboard
  • Compatible with 1x, 4x, 8x and 16x PCI-E slots

Specifications

BrandITHOO
TypeRiser Cable
Length2FT
Cable Length2 ft.
Specifications3 High Quality Solid Capacitors, Voltage Regulation, and Overcurrent Protection. 60cm USB 3.0 riser cable enabling flexibility in the placement of your PCI-E devices. Molex 4 PIN interface allows card to run off of separate power rails independent from motherboard effectively reducing power strain on motherboard Version 008S riser kits are the perfect solution for setting up Ethereum mining rigs (or any other GPU-mined altcoin), whether small open air rigs or large rack based miners. Compatible with 1x, 4x, 8x,16x PCI-E motherboard slots for ethereum mining Note: Please set BIOS PCIe

Questions about this item

Should I buy the 10-pack or are smaller quantities available?

This listing is only offered as a 10-pack; each pack contains ten riser cards with 2ft USB 3.0 cables and Molex 4-pin power connectors.

Will my GPU run at full 16x speed through the 1x to 16x riser?

The riser converts a physical 1x slot to a 16x connector, but electrical bandwidth remains limited to 1x; the supplier advises setting the BIOS to Gen 2 or Gen 1 if the card is not detected.

What does the Molex 4-pin power connector actually do for the riser?

It draws auxiliary power directly from the PSU via a Molex 4-pin rail, reducing the load on the motherboard slot and providing voltage regulation plus overcurrent protection through three solid capacitors.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.