Elemental LED
Elemental LED DI-0918-LPS3R LO-PRO Wet Loc Jct Box Driver Combo 12V 35W Ballast
A 12V 35W constant voltage driver in a NEMA 3R junction box rated for wet locations
- typeBallasts
- Constant-voltage driver pairs with 120 V switches and dimmers
- 35 W Class 2 output powers low-voltage LED runs
- NEMA 3R junction box shields electronics from weather
- Certified to UL 2108, UL 508A and UL 1598 standards
- Designed and engineered in Reno, Nevada
What This Combo Powers
This 12 V, 35 W constant-voltage driver and NEMA 3R junction-box pair is built for low-voltage LED runs that need a weather-tight enclosure. It suits installers wiring outdoor or damp-location strips, fixtures or RGB/DMX systems where a hard-wired, Class 2 supply is required.
Sustained-Load Behaviour
The driver maintains steady 12 V output across its 35 W rating without the voltage sag common in short-burst supplies. UL 2108, UL 508A and UL 1598 listings confirm the assembly survives continuous operation inside the sealed NEMA 3R box while resisting moisture, dust and temperature cycling.
What It Replaces
The combo replaces a separate driver plus a generic junction box when code demands a UL-listed wet-location enclosure. The jump is worth it on new builds or retrofits where a single, pre-wired unit cuts labour and eliminates mismatched components, but it will not serve loads above 35 W or voltages other than 12 V.
Highlights
- Constant-voltage driver pairs with 120 V switches and dimmers
- 35 W Class 2 output powers low-voltage LED runs
- NEMA 3R junction box shields electronics from weather
- Certified to UL 2108, UL 508A and UL 1598 standards
- Designed and engineered in Reno, Nevada
Specifications
| Brand | DIODE LED |
|---|---|
| type | Ballasts |
Questions about this item
How much heat and noise does the 35 W driver produce when it runs continuously?
The 35 W constant-voltage driver is passively cooled inside a sealed NEMA 3R junction box, so it generates only modest warmth and no fan noise during all-day operation.
What must I already have on site to install this junction-box-and-driver combo?
You need a 120 V AC supply circuit, low-voltage LED tape or fixtures rated for 12 V DC, and basic hard-wiring tools to connect the driver leads inside the enclosure.
Will the NEMA 3R box and UL 2108 listing let me keep using my older 12 V LED strips outdoors?
Yes — the wet-location box is UL 2108, UL 508A and UL 1598 certified, so it protects the 35 W driver and your existing 12 V strips from rain and dust.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



