We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 3ft flat 2-prong polarized power cord with open end

E ENERSYSTEC EENERSYSTEC-123 18AWG 3ft 2 Prong Polarized Computer Power Cord

SKU CH-WXBA-Z8SJZ

Supplies 120 V AC power at up to 10 A with an 18 AWG polarized cord and open ends for wiring

  • Length3 Feet
  • Connector DetailMale-to-Male
  • SpecificationsVoltage: 120 volts; Current: 10 amps; Connector: Male-to-Mal
  • Polarised plug ensures correct 120 V connection
  • 18 AWG copper conductors handle 10 A continuous current
  • 3 ft flat cable keeps routing tidy
  • Open-ended design allows direct wiring without soldering
  • UL listed construction supports 1250 W maximum load

What this cord replaces

The E ENERSYSTEC EENERSYSTEC-123 is a three-foot, 18AWG two-prong polarized power cord rated for 120 V AC at 10 A. It carries a UL listing and a maximum load of 1250 W. The open-ended male-to-male design lets installers wire the far end directly to a device or terminal block without soldering.

Rating that decides fit

The cord is specified for 120 V and 10 A continuous, with a 1250 W ceiling. Equipment drawing more than 10 A or operating above 120 V must not use this lead. A 20 % margin below the rated maximum is advised for sustained operation.

Heat, noise and draw in use

Pure copper 18AWG conductors keep resistive heating low at rated current. The flat two-conductor jacket stays flexible for routing. No fan or active cooling is present, so the cord runs silently. Power loss is limited to normal I²R drop within the 1250 W rating.

Highlights

  • Polarised plug ensures correct 120 V connection
  • 18 AWG copper conductors handle 10 A continuous current
  • 3 ft flat cable keeps routing tidy
  • Open-ended design allows direct wiring without soldering
  • UL listed construction supports 1250 W maximum load

Specifications

BrandE ENERSYSTEC
ModelEENERSYSTEC-123
Length3 Feet
Connector DetailMale-to-Male
SpecificationsVoltage: 120 volts; Current: 10 amps; Connector: Male-to-Male; UL Listed: true

Questions about this item

What does the 1250W rating mean for my appliance?

The cord handles up to 1250 watts at 120 volts AC, so any device drawing 10 amps or less can run safely without overheating the cable.

How does the 120V AC rating limit what I can plug in?

It restricts use to standard 120 volt household outlets; connecting to higher voltage circuits will damage the cord and the equipment.

What do I need to fit the open end of this cord?

The open end requires a wiring connector or soldering to the appliance terminal block; no plug is pre-installed on the device side.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.