We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Red 600 mm internal cable with spade and DuPont connectors

Dimastech

Dimastech Switch Cable Red 600mm internal power cable

SKU CH-3R14-6XJCM

Connects a vandal-resistant switch to a motherboard using spade and DuPont connectors across a 600mm length

  • Cable Length1.97 ft.

Color Red 600mm

  • Connects vandal-resistant switch to motherboard via spade and DuPont connectors
  • 600 mm length fits standard case layouts
  • Red jacket simplifies cable identification during builds
  • Pre-assembled spade and 2-pin DuPont ends require no crimping
  • Single 600 mm cable included for immediate installation

Switch Connection Cable

This 600 mm red cable links a vandal-resistant switch to a motherboard header. One end uses spade terminals for the switch while the opposite end provides a 1 and 2 pin DuPont connector for the board. It is intended for builders adding a durable external power or reset button to a custom chassis. The BT108 model ships as a single cable in new condition.

Front Panel Header Upgrade

The cable replaces a missing or damaged front-panel lead that connects a heavy-duty switch to the motherboard. It is worth fitting when the original wiring is too short, has failed, or when a project requires a vandal-resistant switch with spade terminals. The 1.97 ft length suits mid-tower and larger cases where the switch mounts farther from the header.

Compatibility Check

Verify that your motherboard offers a standard two-pin header for the DuPont side of the cable. Confirm the vandal-resistant switch you plan to use accepts spade connectors on its terminals. No other interface or voltage specification is involved, so the only requirements are physical connector match and sufficient cable reach for your build.

Highlights

  • Connects vandal-resistant switch to motherboard via spade and DuPont connectors
  • 600 mm length fits standard case layouts
  • Red jacket simplifies cable identification during builds
  • Pre-assembled spade and 2-pin DuPont ends require no crimping
  • Single 600 mm cable included for immediate installation

Specifications

Cable Length1.97 ft.

Other versions of this model

3 more in the same range

Same family, different memory, cooler or clock — compare before you commit.

Questions about this item

How much clearance do I need for the 600 mm cable run between the switch and motherboard?

The cable measures 600 mm (1.97 ft) end to end, so allow at least that much free routing space plus slack for the spade and DuPont ends to seat without tension.

Which way round do the spade and DuPont connectors go when I plug them in?

Push the spade terminals onto the vandal-resistant switch tabs first, then insert the 1-and-2-pin DuPont plug into the motherboard front-panel header — reversing them leaves the switch unpowered.

When should I replace this cable if the power-switch connection becomes unreliable?

Replace it if the spade lugs loosen on the switch tabs, the DuPont pins bend or oxidise, or the red insulation shows cracking after repeated case moves.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.