We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pair of 800mm black and red cables with spade and DuPont connectors

Dimastech

Dimastech BT112 800mm Black & Red Internal Power Cable Pair

SKU CH-TDZC-PRQ38

A pair of 800 mm cables linking a vandal-resistant switch to a motherboard via spade and DuPont connectors

  • Cable Length2.6 ft.
  • Connect vandal-resistant switch to motherboard with dedicated cable pair
  • 800 mm length provides flexible routing inside case
  • Spade connectors fit switch terminals securely
  • 1 and 2 pin DuPont plugs into motherboard header
  • Includes one black and one red cable for identification

Connecting Vandal-Resistant Switches

This pair of cables links a vandal-resistant switch to a motherboard front-panel header. Each 800mm lead terminates in spade connectors on the switch side and a 1 and 2 pin DuPont connector on the board side. The red and black colour coding helps identify polarity during installation. They suit custom chassis builds that use ruggedised power or reset buttons.

Passive Wiring Thermals

The cables carry only low-voltage signalling current, so they generate no measurable heat during normal operation. No active cooling or airflow consideration is required for the wiring itself. Power draw is negligible and produces no audible noise. Routing them alongside other front-panel leads has no thermal impact on surrounding components.

Bundled Pair Simplifies Wiring

The box contains one black and one red cable, both 800mm long, providing the two conductors needed for a single switch connection. Colour-coded insulation reduces wiring errors when mating the DuPont header to the motherboard pinout. No additional connectors, adapters or software are supplied or required.

Highlights

  • Connect vandal-resistant switch to motherboard with dedicated cable pair
  • 800 mm length provides flexible routing inside case
  • Spade connectors fit switch terminals securely
  • 1 and 2 pin DuPont plugs into motherboard header
  • Includes one black and one red cable for identification

Specifications

Cable Length2.6 ft.

Questions about this item

How do I install the BT112 cables between my vandal resistant switch and motherboard?

Connect the spade terminals to the switch terminals, then plug the 1-pin and 2-pin DuPont connectors into the matching motherboard header pins, observing the correct polarity for each colour.

Will the spade or DuPont connectors on these 800mm cables need periodic replacement?

The crimped spade and DuPont contacts are rated for the life of the build; reseat them only if a connection becomes loose after transport or vibration.

What is the maximum cable run before voltage drop affects the switch signal?

The supplied 800mm length is designed for typical case routing; extending beyond that with additional wire may introduce resistance that prevents reliable switch operation.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.