We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

DELL

DELL PowerEdge R340 SAS Cable VXP83 46cm

SKU CH-YMAA-BZ6QC

SAS RAID cable connects an eight-bay backplane to the controller in a PowerEdge R340 server

  • TypeSAS Cable
  • ColorBlack
  • Connects 8-bay backplane to RAID controller
  • 46 cm length fits R340 2.5 inch chassis
  • Dual SFF-8087 connectors for direct RAID link
  • Enables RAID storage redundancy and performance
  • Genuine Dell VXP83 part for R340 servers

Purpose-built SAS cable for Dell PowerEdge R340

This 46 cm SAS RAID cable connects the eight-bay 2.5" backplane to the RAID controller in a Dell PowerEdge R340 server. It carries data between the controller and up to eight SAS drives, enabling RAID configurations that improve storage reliability. The part number VXP83 identifies the exact fit for this server model.

Thermals, noise and power draw

The cable itself is passive and adds no heat, noise or measurable power draw to the system. It simply routes signals between the backplane SFF-8087 connectors and the RAID card, so thermal and acoustic behaviour depends entirely on the drives and controller it serves.

What the bundled items change

No additional accessories or software are included with this cable. Installation is a direct replacement: remove the old cable and seat the VXP83 between the backplane and controller to restore full SAS connectivity for the eight drive bays.

Highlights

  • Connects 8-bay backplane to RAID controller
  • 46 cm length fits R340 2.5 inch chassis
  • Dual SFF-8087 connectors for direct RAID link
  • Enables RAID storage redundancy and performance
  • Genuine Dell VXP83 part for R340 servers

Specifications

BrandDell
ModelPowerEdge R340
TypeSAS Cable
ColorBlack

Questions about this item

How do I route the 46 cm SAS cable from the 8087 ports on the RAID controller to the backplane in the PowerEdge R340?

Connect each SFF-8087 end to the matching controller and backplane ports, then secure the latch clips; the short 46 cm length requires careful dressing so the cable does not block airflow or interfere with drive caddies.

What maintenance does the VXP83 SAS cable need during the server's life?

No scheduled maintenance is required; inspect the connectors for dust or bent pins only when the chassis is open for drive replacement, and reseat the latches if a drive bay reports link errors.

What is the first limit that appears when the cable runs at full SAS throughput continuously?

The 46 cm fixed length is the primary constraint; it restricts controller placement and offers no slack for re-routing, so thermal stress on the connectors becomes the limiting factor under sustained load.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.