DELL
DELL PA-10 DA90PS0-00 XD757 90W 19.5V 4.62A power adapter for Alienware Inspiron
A 90W 19.5V 4.62A AC adapter with 100-240V input and included power cord for compatible Dell laptops
- Genuine Dell replacement keeps your Alienware or Inspiron running
- 90 W output at 19.5 V 4.62 A matches original spec
- Worldwide 100-240 V 50-60 Hz input works anywhere
- Built-in protection guards against wrong voltage, shorts and overheating
- Power cord included so you can plug in immediately
Genuine Dell 90W replacement adapter
This genuine Dell PA-10 adapter delivers 19.5 V at 4.62 A for 90 W of continuous power. It matches the DA90PS0-00 XD757 specification used by Alienware and Inspiron laptops. The unit ships new with a power cord included. It is intended for owners replacing a lost or damaged original charger.
Wide-range input with built-in protections
The adapter accepts 100-240 V at 1.5 A across 50-60 Hz mains worldwide. Internal safeguards protect against incorrect voltage, short circuit and internal overheating during normal use. The brick runs at the rated 90 W output without external fan noise. No additional configuration is required.
Direct swap for failed or missing OEM units
This unit replaces a factory-supplied 90 W Dell adapter with the same barrel connector and voltage. The upgrade is worthwhile when the original charger is lost, physically damaged or no longer holds a stable output. It is not suitable for systems requiring higher wattage or a different connector type.
Highlights
- Genuine Dell replacement keeps your Alienware or Inspiron running
- 90 W output at 19.5 V 4.62 A matches original spec
- Worldwide 100-240 V 50-60 Hz input works anywhere
- Built-in protection guards against wrong voltage, shorts and overheating
- Power cord included so you can plug in immediately
Specifications
No published specifications for this item yet.
Questions about this item
How do I connect the Dell PA-10 adapter and what step is often missed?
Plug the barrel tip firmly into the laptop's power jack, connect the IEC C5 cord to the brick, then insert the mains plug into a 100-240V 50-60Hz outlet; the step often missed is seating the cord fully into the adapter body until it clicks.
What part of the Dell PA-10 will need replacement first over time?
The detachable IEC C5 power cord and the barrel-tip cable see the most physical stress; the cord can be swapped separately, while tip wear may eventually require a new adapter.
What limit appears first when the Dell PA-10 runs continuously at full load?
The 90W output ceiling at 19.5V 4.62A is reached before any thermal throttle; internal overheating protection (IO) will trip if sustained draw exceeds the rated wattage.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



