DELL
DELL Latitude 7520 15.6" FHD 250-nits LCD Ribbon Cable W5H84
Genuine Dell OEM 15.6-inch FHD 250-nits LCD ribbon cable with 6mm IR camera for Latitude 7520, part W5H84
- Typelaptop-computer-replacement-parts
- Genuine Dell OEM part ensures exact fit for Latitude 7520
- Designed for 15.6 inch FHD 250-nits non-touch display
- Supports optional 6mm IR infrared web camera assembly
- Matches Dell part number W5H84 and alt GDC50_MB-LCD-CAM_250FHD_NTS_6IR_ASSY
- Replacement cable restores video and camera connection reliably
Genuine Dell OEM replacement cable
This is a genuine Dell OEM LCD video ribbon cable built for the Latitude 7520. It matches part number W5H84 and the alternate reference GDC50_MB-LCD-CAM_250FHD_NTS_6IR_ASSY. The cable is designed for 15.6 inch FHD panels rated at 250 nits brightness. Buyers with touch-screen models or different brightness specifications cannot use this part.
Passive signal carrier
The ribbon carries video and camera signals without active electronics, so it adds no heat and draws no power. Operation is silent because there are no moving parts or fans. Thermal behaviour depends entirely on the laptop's own cooling system.
Delicate flat-flex construction
The thin flat-flex design requires careful routing inside the display hinge area to avoid creasing. Connectors on each end mate with the motherboard and the LCD assembly that includes the 6 mm IR camera module. Installers must verify the existing cable part number before fitting, as the 7520 uses several different cables across screen variants.
Highlights
- Genuine Dell OEM part ensures exact fit for Latitude 7520
- Designed for 15.6 inch FHD 250-nits non-touch display
- Supports optional 6mm IR infrared web camera assembly
- Matches Dell part number W5H84 and alt GDC50_MB-LCD-CAM_250FHD_NTS_6IR_ASSY
- Replacement cable restores video and camera connection reliably
Specifications
| Brand | Dell |
|---|---|
| Type | laptop-computer-replacement-parts |
Questions about this item
How do I install the W5H84 ribbon cable on my Latitude 7520, and what step is most often missed?
Remove the bottom cover and battery first. Route the cable through the hinge channel exactly as the original lay, then seat both the display-end and motherboard-end connectors fully. The step most people miss is re-taping the cable to the panel frame so it cannot flex when the lid moves.
What maintenance or replacement will the W5H84 cable need over time?
The cable itself has no service schedule. Inspect it if the display flickers, shows lines, or the IR camera stops working after repeated lid cycles. Replace the cable only if the conductors or the 6 mm IR camera flex are physically damaged.
What is the first limit that appears when the W5H84 cable is used continuously with the lid opening and closing?
Repeated bending at the hinge is the first wear point. The 6 mm IR camera flex and the 250-nits FHD video traces can fatigue, causing intermittent video or camera loss before the connectors themselves fail.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



