DELL
DELL Inspiron 7500 7501 15.6" LCD Video Ribbon Cable JV5N5
Genuine Dell OEM 15.6" LCD video ribbon cable for non-touch Inspiron 7500 and 7501 laptops, part number JV5N5
- Typelaptop-computer-replacement-parts
- Genuine Dell OEM replacement ensures exact fit
- Designed for 15.6 inch non-touch displays on Inspiron 7500 and 7501
- Part number JV5N5 matches Dell service documentation
- OEM quality ribbon cable restores video signal reliability
- Direct replacement for mkb_H15_edp_nontouch and 450.0KG06.0001
Genuine Dell OEM LCD Video Ribbon Cable
This is a genuine Dell OEM replacement part for 15.6 inch Inspiron 7500 and 7501 laptops equipped with non-touchscreen displays. It carries the Dell part number JV5N5 and matches the supplier reference 450.0KG06.0001. The cable restores the video link between the motherboard and the LCD panel.
Thin ribbon design fits the original routing
The flat ribbon construction follows the factory hinge path inside the chassis, so it installs without modifying brackets or adding bulk. Connectors on each end mate directly with the board and panel sockets used on the listed models. No adapters or extra hardware are required for the swap.
Passive component draws no extra power
As a passive ribbon cable it adds no thermal load and generates no audible noise during operation. Signal integrity depends on a clean, fully seated connection at both ends. Normal use simply requires careful routing to avoid pinch points when the display is opened and closed.
Highlights
- Genuine Dell OEM replacement ensures exact fit
- Designed for 15.6 inch non-touch displays on Inspiron 7500 and 7501
- Part number JV5N5 matches Dell service documentation
- OEM quality ribbon cable restores video signal reliability
- Direct replacement for mkb_H15_edp_nontouch and 450.0KG06.0001
Specifications
| Brand | Dell |
|---|---|
| Type | laptop-computer-replacement-parts |
Questions about this item
Does the 15.6" ribbon cable carry an eDP signal for the non-touch display?
Yes, the part number mkb_H15_edp_nontouch confirms it is an eDP video ribbon for the 15.6" non-touch LCD on Inspiron 7500 and 7501.
Which connector ends must match the motherboard and panel on the Inspiron 7500?
The cable has the exact Dell OEM connectors for the JV5N5 part, fitting the motherboard header and the 15.6" non-touch panel socket.
What is the correct routing step that prevents a black screen after replacement?
Route the ribbon through the hinge channel without twisting, then seat both ZIF connectors fully before locking the retention flaps.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



