We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black USB to 12V fan adapter cable with inline transformer and 4-pin connector, 50cm length

Darkside

Darkside USB to 12V Fan Adapter Cable 50cm Black DS-1043

SKU CH-E9KJ-F18V2

Converts a USB port to 12 V for a single 3-pin or 4-pin fan with a 50 cm cable

  • Cable Length1.6 ft.
  • Powers 12 V fans from a USB port using built-in step-up transformer
  • Draws up to .5 A on USB 2.0 and .9 A on USB 3.0 without exceeding spec
  • 4-pin connector fits both 3-pin and 4-pin fans for broad compatibility
  • 50 cm length gives flexible routing inside compact cases
  • Black Jet Back sleeving protects wires and keeps build looking clean

USB 12 V fan adapter for low-power cooling

This cable converts a standard USB port into a 12 V supply for a single 3-pin or 4-pin fan. It is intended for builders who need a simple way to run a case or radiator fan from a motherboard header or powered hub without a dedicated fan controller.

Limited by USB current specifications

The integrated step-up transformer delivers 12 V but the source port caps available current at .5 A on USB 2.0 or .9 A on USB 3.0. Fans drawing more than the port rating will not spin reliably and may trigger port protection, so only low-power models are suitable.

Check fan current draw

Verify the fan’s rated amperage stays below the limit of the USB port you plan to use. A 50 cm / 1.6 ft cable length restricts placement to devices near the port, and the single 4-pin connector supports one fan only.

Highlights

  • Powers 12 V fans from a USB port using built-in step-up transformer
  • Draws up to .5 A on USB 2.0 and .9 A on USB 3.0 without exceeding spec
  • 4-pin connector fits both 3-pin and 4-pin fans for broad compatibility
  • 50 cm length gives flexible routing inside compact cases
  • Black Jet Back sleeving protects wires and keeps build looking clean

Specifications

Cable Length1.6 ft.

Questions about this item

Which length should I pick for a standard ATX case?

The cable is 50 cm long, which reaches most rear or top fan mounts from a motherboard USB header or rear port.

What does the 12 V output mean for my fan?

The built-in transformer steps the USB 5 V supply up to 12 V so a standard 12 V PWM or voltage-controlled fan runs at full speed.

How does the USB 2.0 versus 3.0 port affect the fan I can connect?

On a USB 2.0 port the adapter is limited to 0.5 A, so the fan must draw 0.5 A or less; on a USB 3.0 port the limit rises to 0.9 A.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.