We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short black cable with 4-pin Molex connectors on both ends

Darkside Computer Modding

Darkside Computer Modding DS-0373 4" 4-Pin Molex Pass-Through Cable

SKU CH-EM7D-EZHR6

A 4-inch 4-pin Molex pass-through cable that extends power to modding LEDs while keeping the connector free for another device

  • Cable Length4 in.
  • 4-inch cable keeps custom LED wiring tidy
  • 4-pin Molex pass-through preserves power ports for other devices
  • Universal DarkSide Connect design fits multiple LED modules
  • Type 7s connector links LED directly to standard Molex supply
  • 10 cm length reduces excess cable clutter in tight builds

What this cable does

The Darkside Computer Modding DS-0373 is a 4-inch 4-pin Molex pass-through cable designed for custom PC builders. It connects CONNECT LED lighting products to a standard Molex power source while keeping the connector free for another device. The short length helps reduce cable clutter inside the chassis.

When to use a pass-through lead

This cable replaces a direct Molex-to-LED link when you need to daisy-chain power to another component. The jump is worth it if your build uses CONNECT-series lighting and you want to keep a Molex socket available without running a separate wire from the power supply. It suits modders who prefer a tidy internal layout.

Check before ordering

Verify that your LED strip or fan uses the CONNECT interface compatible with Type 7s wiring. Ensure the 4-inch reach spans the gap between your Molex connector and the lighting unit without tension. Confirm your power supply has a free 4-pin Molex header to accept the pass-through plug.

Highlights

  • 4-inch cable keeps custom LED wiring tidy
  • 4-pin Molex pass-through preserves power ports for other devices
  • Universal DarkSide Connect design fits multiple LED modules
  • Type 7s connector links LED directly to standard Molex supply
  • 10 cm length reduces excess cable clutter in tight builds

Specifications

Cable Length4 in.

Questions about this item

What clearance is needed for the 4-inch Molex pass-through cable?

The cable measures 4 inches (10 cm) end to end, so allow at least that much straight run plus room for the Molex connectors on each side.

How do you install the Type 7s pass-through without losing power to the next device?

Plug the male Molex into your PSU or existing chain, then attach the female Molex to the following component; the LED lead draws power in parallel without breaking the chain.

When should the pass-through cable be replaced in a custom loop build?

Replace it if the Molex pins loosen, the insulation cracks from repeated bending, or you change to a different LED connector type.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.