We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short black Y-cable splitting one 4-pin Molex plug into two sockets

Darkside Computer Modding

Darkside Computer Modding DS-0371 4-Pin Molex Y-Cable 4 in

SKU CH-5QYG-SGD2X

A 4-inch 4-pin Molex Y-cable splits one connector into two for LED modding

  • Cable Length4 in.
  • Splits one Molex connector into two LED feeds
  • 10 cm length keeps cable routing tidy
  • Type 6s design matches DarkSide CONNECT LED range
  • Universal extension simplifies LED power swaps
  • New cable ready for immediate system integration

Darkside DS-0371 Molex Y-Cable Purpose

This 4-inch Y-cable splits a single 4-pin Molex connector into two outputs for DarkSide CONNECT LED modules. It suits modders who want to power a pair of lights from one supply lead without running extra wiring from the PSU. The short length keeps routing tidy inside compact builds.

Sustained Load Behaviour

The cable uses standard 4-pin Molex pins rated for continuous current within the ATX specification. Under steady lighting loads the conductors and crimps remain stable without voltage sag that could dim LEDs. No active components are present so thermal throttling does not occur.

Pre-Installation Checks

Verify that your power supply has a free 4-pin Molex perimeter connector and that the 4-inch reach spans the gap to both LED modules. Confirm the LED units use the DarkSide CONNECT Type 6s interface so the keyed plugs seat correctly. Ensure case routing allows the Y-junction to sit without strain on the leads.

Highlights

  • Splits one Molex connector into two LED feeds
  • 10 cm length keeps cable routing tidy
  • Type 6s design matches DarkSide CONNECT LED range
  • Universal extension simplifies LED power swaps
  • New cable ready for immediate system integration

Specifications

Cable Length4 in.

Questions about this item

Does the 4-pin Molex Y-cable generate any heat or noise when powering LEDs continuously?

The cable is a passive power splitter with no active components, so it produces no noise and negligible heat during continuous operation.

What existing power connector must my power supply provide for this DS-0371 cable to work?

Your power supply needs a standard 4-pin Molex output to plug the male end of this Y-cable into.

Will the 10 cm length reach from an older Molex connector to two CONNECT LED strips in a full-tower case?

At 10 cm the cable is designed for tight, local connections; you may need an extension if the LED strips are far from the Molex source.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.