We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short 4-inch 3-pin pass-through power extension cable

Darkside Computer Modding

Darkside Computer Modding CONNECT Pass-Through Cable 4" 3-Pin Type 3s DS-0365

SKU CH-D483-3PG7T

A 4-inch pass-through cable with a 3-pin fan connector extends power to modding LEDs while reducing internal clutter

  • Cable Length4 in.
  • Universal power extension for modding LEDs
  • 3-pin pass-through connects to motherboard or fan controller
  • 4-inch length reduces cable clutter in custom builds
  • Type 3s design lets you swap connectivity without replacing LED units
  • DarkSide Connect range supports unique system builds

4-Inch 3-Pin Pass-Through Cable

This four-inch extension carries a 3-pin fan connector through to a motherboard header or fan controller. It is designed for modders who need a short, tidy link between an LED lighting product and a 3-pin power source inside a custom build. The compact length keeps routing clean in tight chassis spaces.

Type 3s Connector Flexibility

The Type 3s interface lets you swap the cable end to match different LED products without replacing the entire lighting unit. You can change connectivity styles as your mod evolves, reducing waste and simplifying future upgrades. The pass-through design preserves the original header for additional fans or devices.

Header Spacing and Pin Alignment

Verify that your motherboard or controller offers a standard 3-pin header with the correct pin pitch for this cable. Ensure the four-inch reach spans the distance between your LED mount and the header without strain. Confirm that no adjacent components block the connector once installed.

Highlights

  • Universal power extension for modding LEDs
  • 3-pin pass-through connects to motherboard or fan controller
  • 4-inch length reduces cable clutter in custom builds
  • Type 3s design lets you swap connectivity without replacing LED units
  • DarkSide Connect range supports unique system builds

Specifications

Cable Length4 in.

Questions about this item

Will the 3-pin pass-through connector wear out from repeated fan swaps?

The 3-pin pass-through is rated for standard mating cycles; avoid excessive force when connecting or disconnecting fans to preserve pin tension.

What stops the 4-inch cable from limiting airflow in a tight build?

At 4 inches the cable adds minimal bulk, letting you route it behind motherboard trays or along PSU shrouds without blocking intake paths.

Does the cable get warm when powering LED mods all day?

The short 10 cm length keeps resistance low, so the cable stays cool even with continuous power draw from modding LEDs.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.