We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 12-inch 3-way splitter cable with three 3-pin connectors

Darkside Computer Modding

Darkside Computer Modding CONNECT 3-Way Type 10 12" internal power cable

SKU CH-A5G5-SYTE8

A 12-inch 3-way splitter cable connects three LEDs to a single motherboard or fan controller header

  • Cable Length1 ft.
  • Universal 3-way splitter connects three LEDs to one header
  • Type 10 pinout ensures correct orientation for modding LEDs
  • 12-inch length reaches components without excess cable slack
  • DarkSide Connect system lets you swap cable types without replacing LED units
  • Reduces internal cable clutter for cleaner custom builds

Universal LED Power Splitter

The Darkside Computer Modding CONNECT Type 10 cable splits a single 3-pin fan header into three connections for modding LEDs. Builders adding accent lighting to a custom system can power multiple strips from one motherboard or fan-controller output without rewiring the entire loom.

Passive Thermals and Zero Noise

The cable assembly contains no active components, so it adds no heat and produces no audible noise during operation. Power draw is limited to the combined load of the attached LEDs and remains within the rating of the source header.

Modular Connector Ecosystem

The Type 10 designation identifies this 3-way splitter as part of a wider DarkSide Connect range that lets builders swap cable ends instead of replacing whole LED kits. This reduces internal clutter and simplifies future lighting changes.

Highlights

  • Universal 3-way splitter connects three LEDs to one header
  • Type 10 pinout ensures correct orientation for modding LEDs
  • 12-inch length reaches components without excess cable slack
  • DarkSide Connect system lets you swap cable types without replacing LED units
  • Reduces internal cable clutter for cleaner custom builds

Specifications

Cable Length1 ft.

Questions about this item

How do I install the 12" Type 10 splitter and what step do people miss?

Plug the single 3-pin connector into your motherboard or fan controller header, then attach each of the three LED leads; the step often missed is aligning the keyed notch on every plug before pressing it home.

What maintenance or replacement will the 30 cm cable need later?

No scheduled maintenance is required; only replace the cable if the insulation is cut, a pin is bent, or a connector becomes loose after repeated disconnects.

What limit appears first when three LEDs run continuously on this splitter?

The motherboard or fan controller header’s current rating is the first limit; the splitter itself is passive wiring and adds no active restriction.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.