We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Darkside 12-inch 3-pin internal power extension cable

Darkside Computer Modding

Darkside Computer Modding CONNECT 12" 3-Pin Type 1 DS-0322 internal power cable

SKU CH-Y7ZK-HVPDV

A 12-inch 3-pin power extension cable for connecting LED mods to a motherboard or fan controller

  • Cable Length1 ft.
  • Universal 12" power extension for flexible LED modding
  • 30 cm length reaches components without excess cable
  • 3-pin fan connector fits motherboard or fan controller
  • Type 1 design enables quick connectivity changes
  • Reduces clutter in custom builds with clean routing

Universal power extension cable

The DarkSide CONNECT 12" cable provides a 3-pin fan power extension for custom computer builds. It is designed for modders who need flexible routing to reach LED lighting or fan headers. The cable simplifies connectivity changes without replacing the entire LED product. It suits builders tidying cable runs inside a case.

3-Pin Type 1 connector

This cable uses a 3-pin fan power connector designated as Type 1. That interface allows direct connection to a motherboard fan header or a compatible fan controller. The single specification determines whether the cable matches the target header on the board or controller. Verify the header pin count before purchase.

12-inch length for tight routing

At 12 inches (30 cm) the cable bridges short gaps between components and headers. It reduces excess slack that adds clutter in compact custom systems. The length frees up space around the motherboard tray while keeping the connection secure. It works alongside other DarkSide CONNECT cables for a consistent modding setup.

Highlights

  • Universal 12" power extension for flexible LED modding
  • 30 cm length reaches components without excess cable
  • 3-pin fan connector fits motherboard or fan controller
  • Type 1 design enables quick connectivity changes
  • Reduces clutter in custom builds with clean routing

Specifications

Cable Length1 ft.

Questions about this item

How far will the 12-inch length reach inside my case?

The cable measures 12 inches (30 cm), giving enough slack to route from a motherboard header to a fan or LED strip without pulling tight.

What does the 3-Pin Type 1 connector actually plug into?

Type 1 fits a standard 3-pin fan header on a motherboard or fan controller, carrying power and tachometer signal for PWM or voltage control.

What clearance do I need to route this cable behind the motherboard tray?

A flexible 12-inch (30 cm) sleeve with a low-profile 3-pin plug fits through typical grommets and tight routing channels in modern cases.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.