We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short black sleeved Y cable with dark blue connectors

Darkside Computer Modding

Darkside Computer Modding 6" RGB Y-Cable Jet Black Sleeved DS-0539 internal power cable

SKU CH-WSWB-HKE7C

A 15 cm splitter cable connects two DarkSide RGB lights to one controller header

  • Cable Length6 in.
  • Connects two RGB lights to one controller header using a 6" Y-splitter cable
  • 15 cm jet-black sleeved cable keeps internal routing tidy and discreet
  • Darkside Modular CONNECT plugs ensure a secure, keyed fit every time
  • Designed exclusively for DarkSide RGB lighting — no other devices supported
  • Model DS-0539 identifies the exact splitter for easy reordering

DarkSide 6" RGB Y-Cable DS-0539

The DarkSide 6" RGB Y-Cable DS-0539 is a jet black sleeved internal power cable designed for custom PC lighting builds. It splits a single DarkSide RGB Controller header to run two DarkSide RGB lights simultaneously. The 15 cm length keeps cable routing tidy inside compact cases. This accessory is built exclusively for DarkSide modular lighting ecosystems.

Upgrade from single-header limit

This cable replaces the need for a second controller header when expanding a DarkSide RGB setup. The jump is worth it when your controller ports are fully occupied but you want to add more matching lights. It draws power for both lights through the existing header without extra wiring. The fixed 15 cm reach suits clean, short-run installations.

Builders extending DarkSide RGB runs

The Y-cable suits builders adding a second DarkSide light to an occupied controller header. It is not for users without DarkSide RGB components or those needing longer cable runs beyond the fixed length. Buyers wanting to mix lighting brands or power non-RGB devices should look at something else. The connector is keyed for DarkSide Modular CONNECT only.

Highlights

  • Connects two RGB lights to one controller header using a 6" Y-splitter cable
  • 15 cm jet-black sleeved cable keeps internal routing tidy and discreet
  • Darkside Modular CONNECT plugs ensure a secure, keyed fit every time
  • Designed exclusively for DarkSide RGB lighting — no other devices supported
  • Model DS-0539 identifies the exact splitter for easy reordering

Specifications

Cable Length6 in.

Questions about this item

What connector does the 6" RGB Y-Cable use to attach to the DarkSide RGB Controller?

The cable uses the Darkside Modular CONNECT interface on the controller header end.

How do you install the Y-Cable so both RGB lights receive power?

Plug the single Modular CONNECT end into one controller header, then attach each light to the two split leads.

When would the Jet Black sleeved Y-Cable need replacement?

Replace it if the sleeving frays, a connector pin bends, or the split junction shows exposed wire.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.