We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Jet-black pre-sleeved Y-splitter cable with four 3-pin fan connectors, 40 cm long

Darkside Computer Modding

Darkside Computer Modding 3-Pin Dual Push-Pull Radiator Fan Power Y-Cable Splitter Jet Black 40cm DS-0099

SKU CH-1JYB-X509H

Connects four 3-pin fans in push-pull on dual radiators to a single 3-pin power source with a pre-sleeved 40 cm cable

  • Cable Length1.3 ft.
  • Connects four 3-pin fans to one header for push-pull dual-radiator setups
  • 40 cm pre-sleeved cable keeps routing tidy on triple radiators
  • 3 ft length gives flexible placement inside the case
  • Jet-black finish matches dark-themed builds
  • Single 3-pin source powers all four fans simultaneously

3-Pin Y-Cable for Four Fans

This 40 cm splitter connects four 3-pin fans in a push-pull arrangement to a single 3-pin header on a fan controller or motherboard. The pre-sleeved cable is optimised for triple-radiator layouts. Total length is approximately 1.3 ft.

Builders running dual-radiator push-pull

Suits builders who need to power four 3-pin fans from one header while keeping cabling tidy. Not for systems using 4-pin PWM fans, builders who need independent speed control per fan, or loops that require a longer reach than 40 cm.

Single 3-pin header feeds all four fans

The splitter draws combined power through one 3-pin connector, so total fan wattage must stay within the header's rated limit. Exceeding that limit risks shutdown or damage.

Highlights

  • Connects four 3-pin fans to one header for push-pull dual-radiator setups
  • 40 cm pre-sleeved cable keeps routing tidy on triple radiators
  • 3 ft length gives flexible placement inside the case
  • Jet-black finish matches dark-themed builds
  • Single 3-pin source powers all four fans simultaneously

Specifications

Cable Length1.3 ft.

Questions about this item

How do I connect four 3-pin fans in a push-pull setup on a dual radiator using this Y-cable?

Plug the single 3-pin end into your fan controller or motherboard header, then attach each of the four fan connectors to the corresponding fans on both sides of the radiator.

Will the pre-sleeved cables need any special care or replacement over time?

The pre-sleeved wires are built for permanent installation inside the case and do not require routine maintenance or scheduled replacement.

What is the maximum total fan wattage this 40 cm splitter can handle safely?

The cable itself does not set a wattage limit; you must ensure the combined draw of all four fans stays within the rating of the 3-pin power source you are using.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.