Computer Memory Solutions
Computer Memory Solutions 2GB DDR3 1333MHz CL9 240-Pin DIMM
2GB DDR3 1333MHz CL9 DIMM upgrades compatible Gateway DX desktops to 16GB maximum
- Capacity2GB
- Type240-Pin DDR3 SDRAM
- SpeedDDR3 1333 (PC3 10600)
- CAS LatencyCL9
- Timing9-9-9
- Voltage1.5V
- 2GB DDR3 1333MHz CL9 upgrade boosts Gateway DX desktop responsiveness
- 5V unbuffered non-ECC DIMM installs directly into 240-pin slots
- Major-brand chipset and 9-9-9 timing deliver stable data integrity
- Single 2Rx8 module leaves three slots free for future expansion
- CMS compatibility guarantee matches DX4370-UR10 and DX4370G-UW10 systems
Targeted DDR3 Upgrade for Gateway DX Desktops
This 2 GB DDR3 module is built specifically for the Gateway DX4370-UR10 and DX4370G-UW10 desktops. It delivers 1333 MHz speed with CL9 latency at the standard 1.5 V. The single 240-pin DIMM uses unbuffered, non-ECC chips in a 2Rx8 configuration. It installs directly into one of the system's four memory slots.
Replaces Slower or Smaller Factory Modules
The upgrade is worthwhile when the original PC shipped with less than 1333 MHz memory or with only 2 GB total capacity. Adding this stick raises the ceiling toward the 16 GB maximum the platform supports. If the board already runs four matched 1333 MHz modules, the jump adds no further bandwidth.
Limited by DDR3 Platform Constraints
The DDR3 interface caps transfer rates at PC3-10600 regardless of faster modules you might install. The four-slot layout and 16 GB ceiling restrict total capacity well below modern standards. Systems needing more memory bandwidth or larger address space require a newer architecture.
Highlights
- 2GB DDR3 1333MHz CL9 upgrade boosts Gateway DX desktop responsiveness
- 5V unbuffered non-ECC DIMM installs directly into 240-pin slots
- Major-brand chipset and 9-9-9 timing deliver stable data integrity
- Single 2Rx8 module leaves three slots free for future expansion
- CMS compatibility guarantee matches DX4370-UR10 and DX4370G-UW10 systems
Specifications
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM2566410600DIMM |
| Capacity | 2GB |
| Type | 240-Pin DDR3 SDRAM |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| Timing | 9-9-9 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Gateway Dx Desktop Dx4370-Ur10, Dx4370G-Uw10 |
| Package Content | 1 Memory RAM Stick |
Questions about this item
Will the 240-pin DIMM fit the four memory slots in my Gateway DX4370 desktop?
Yes — the module uses the standard 240-pin DDR3 form factor and the DX4370 has four DDR3 DIMM slots, so it installs directly.
What is the correct orientation step when seating the 240-pin DDR3 stick in the DX4370?
Align the notch on the module with the key in the slot, press down evenly until both side clips snap shut — the step often missed is checking that both clips engage fully.
When should I expect to replace this 2 GB DDR3 module in the Gateway DX4370?
DDR3 memory has no moving parts and typically lasts the life of the system; replace only if diagnostics report errors or you upgrade to the 16 GB maximum supported by the DX4370.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
minisforum MF-SRP01 SSD Heatsink accessories barebone
- SSD Heatsink
Intel HNS2600BPS24R 2U barebone pc dual Xeon DDR4 2.80 TB C622
- Xeon Bronze Xeon Go…
- DDR4-2933/PC4-23466



