Computer Memory Solutions
Computer Memory Solutions 16GB (2x8GB) DDR3 1333MHz Non-ECC DIMM Memory Upgrade for Dell Optiplex 790
16 GB dual-channel DDR3-1333 kit in two unbuffered 8 GB DIMMs validated for the OptiPlex 790 MT, DT and SFF desktops
- Capacity16GB (2 x 8GB)
- Type240-Pin DDR3 SDRAM
- SpeedDDR3 1333 (PC3 10600)
- CAS LatencyCL9
- Timing9-9-9
- Voltage1.5V
- 16 GB dual-channel kit boosts multitasking headroom
- 1333 MHz DDR3 speed matches Dell Optiplex 790 spec
- CL9 1.5 V timing ensures stable operation
- 240-pin unbuffered DIMMs install in standard desktop slots
- Guaranteed compatible with Optiplex 790 MT/DT/SFF systems
System-Specific DDR3 Upgrade
This 16 GB kit contains two 8 GB unbuffered DIMMs built for Dell Optiplex 790 MT, DT and SFF desktops. It runs at DDR3 1333 (PC3 10600) with CL9 timings and 1.5 V operation. The modules use major-brand chips and carry a lifetime warranty from the manufacturer.
Upgrading from Lower Capacity or Speed
The kit replaces smaller or slower DDR3 modules to reach the platform maximum of 32 GB across four sockets. Moving to 16 GB is worthwhile when the existing configuration leaves headroom unused or when mixed speeds force the system to run below 1333 MHz. Buyers needing more than 32 GB total capacity or a different memory generation should look elsewhere.
Capacity and Headroom for Everyday Workloads
Sixteen gigabytes handles typical office applications, web browsing with many tabs and light multitasking without paging. The dual-rank 2Rx8 organisation fills two of the four available slots, leaving room for a second identical kit to reach the 32 GB ceiling. Workloads that regularly exceed 16 GB will require the full 32 GB configuration.
Highlights
- 16 GB dual-channel kit boosts multitasking headroom
- 1333 MHz DDR3 speed matches Dell Optiplex 790 spec
- CL9 1.5 V timing ensures stable operation
- 240-pin unbuffered DIMMs install in standard desktop slots
- Guaranteed compatible with Optiplex 790 MT/DT/SFF systems
Specifications
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM10246410600DIMM |
| Capacity | 16GB (2 x 8GB) |
| Type | 240-Pin DDR3 SDRAM |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| Timing | 9-9-9 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Dell Optiplex 790 Mt/Dt/Sff Desktops |
| Package Content | 2 Memory RAM Sticks |
Questions about this item
Does this 240-pin DDR3 kit fit the four DIMM slots in a Dell Optiplex 790 MT, DT or SFF chassis?
Yes, the modules are 240-pin DDR3 DIMMs and the Optiplex 790 MT, DT and SFF desktops each provide four DDR3 slots, so the two sticks install directly.
What is the correct way to seat the 240-pin modules so the motherboard latches engage on the Optiplex 790?
Align the notch on each module with the slot key, press straight down with even pressure on both ends until the side latches snap closed automatically.
Will the 16 GB kit need any firmware updates or battery changes during its service life in the Optiplex 790?
No, DDR3 memory has no firmware and no onboard battery; the only later action might be adding two more 8 GB sticks to reach the 32 GB maximum supported by the system.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
minisforum MF-SRP01 SSD Heatsink accessories barebone
- SSD Heatsink
Intel HNS2600BPS24R 2U barebone pc dual Xeon DDR4 2.80 TB C622
- Xeon Bronze Xeon Go…
- DDR4-2933/PC4-23466



