Computer Memory Solutions
Computer Memory Solutions 16GB (2x8GB) DDR3 12800 1600MHz Non-ECC DIMM for HP Pavilion 500-097 memory upgrade
A 16 GB DDR3 kit with two 8 GB DIMMs running at 1600 MHz CL11 for HP Pavilion 500-097, 500-149, 500-152ea and 500-164 desktops
- Capacity16GB (2 x 8GB)
- Type240-Pin DDR3 SDRAM
- SpeedDDR3 1600 (PC3 12800)
- CAS LatencyCL11
- Timing11-11-11
- Voltage1.5V
- Guaranteed compatibility with HP Pavilion 500-097 and listed models
- 16GB dual-channel kit (2 × 8GB) boosts multitasking headroom
- DDR3-1600 CL11 timing delivers responsive system performance
- 5V unbuffered non-ECC DIMMs install without configuration
- Expands desktop to 32GB maximum supported memory
Compatible HP Pavilion DDR3 upgrade
This 16 GB kit contains two 8 GB unbuffered DIMMs built for HP Pavilion 500-097, 500-149, 500-152Ea and 500-164 desktops. The modules run at DDR3 1600 with CL11 timing at 1.5 V. They install directly into the 240-pin slots to raise total memory toward the 32 GB board maximum.
Suits owners of the listed Pavilion models
Buyers with those exact model numbers gain a guaranteed match backed by the supplier's compatibility pledge. Systems needing ECC, registered modules, or a different DDR generation cannot use this kit. Machines outside the four named models should verify support before ordering.
240-pin DDR3 1600 non-ECC DIMM
The decisive spec is the 240-pin DDR3 1600 unbuffered non-ECC form factor; only boards accepting that exact module type will work. The kit delivers 16 GB in a 2x8 GB layout using 2Rx8 chips at CL11 11-11-11. Confirm your motherboard takes this configuration before purchase.
Highlights
- Guaranteed compatibility with HP Pavilion 500-097 and listed models
- 16GB dual-channel kit (2 × 8GB) boosts multitasking headroom
- DDR3-1600 CL11 timing delivers responsive system performance
- 5V unbuffered non-ECC DIMMs install without configuration
- Expands desktop to 32GB maximum supported memory
Specifications
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM10246412800DIMM |
| Capacity | 16GB (2 x 8GB) |
| Type | 240-Pin DDR3 SDRAM |
| Speed | DDR3 1600 (PC3 12800) |
| CAS Latency | CL11 |
| Timing | 11-11-11 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Hp Pavilion 500-097, 500-149, 500-152Ea, 500-164 |
| Package Content | 2 Memory RAM Sticks |
Questions about this item
Will the 240-pin DDR3 DIMMs fit the four memory slots on my HP Pavilion 500-097?
Yes, each 8 GB module is a standard 240-pin DDR3 DIMM and the Pavilion 500 series provides four DIMM slots, so the pair installs directly.
What is the correct order for seating the two 8 GB sticks so the system recognises the full 16 GB?
Insert the first module into the lowest-numbered slot (usually DIMM1), press firmly until the retention clips click, then repeat with the second module in the next slot; the common mistake is not pressing hard enough to latch both clips.
If I want to reach the 32 GB maximum later, what additional modules should I buy?
Add another matched pair of 8 GB DDR3 1600 CL11 1.5 V unbuffered non-ECC DIMMs to fill the two remaining slots and reach the 32 GB limit.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
minisforum MF-SRP01 SSD Heatsink accessories barebone
- SSD Heatsink
Intel HNS2600BPS24R 2U barebone pc dual Xeon DDR4 2.80 TB C622
- Xeon Bronze Xeon Go…
- DDR4-2933/PC4-23466



