We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Grey 50ft Cat6 snagless ethernet cable with moulded boots

Cables To Go

Cables To Go CTG-27136 50ft Cat6 snagless network ethernet cable

SKU CH-Q5XX-A874Q

A 50 ft Cat6 UTP patch cable rated to 550 MHz, UL verified and built with bonded pairs and snagless boots for reliable gigabit Ethernet runs

  • 50 ft reach for flexible network layouts
  • Cat6 550 MHz bandwidth for data, voice and video
  • UL verified and meets TIA/EIA‑568‑B‑2.1 draft 9
  • Bonded pairs maintain twist spacing to reduce return loss
  • Snagless molded boot prevents catches and adds strain relief

50 ft Cat6 snagless cable

The Cables To Go CTG-27136 is a 50 ft Category 6 UTP patch cable rated for 550 MHz bandwidth. It meets TIA/EIA-568-B-2.1 draft 9 standards and is UL verified for safety compliance. Bonded pair construction maintains twist spacing to the termination point, reducing impedance and structural return loss compared to standard 100 MHz wire.

Suited for structured cabling runs needing

Installers pulling cable through conduit or crowded racks benefit from the molded snag-free boot that prevents catching and provides strain relief. The shortened plug body keeps near-end crosstalk low for stable gigabit links. Buyers needing shielded cable for high-interference environments or outdoor burial-rated jackets should look elsewhere.

Sustained 550 MHz performance under load

Bonded pairs preserve twist geometry during long pulls, keeping impedance stable and structural return loss low when the link runs at full capacity. The shortened plug body limits near-end crosstalk during continuous high-throughput transfers such as video distribution or large file moves. UL verification confirms the materials meet flammability and safety requirements for permanent installation.

Highlights

  • 50 ft reach for flexible network layouts
  • Cat6 550 MHz bandwidth for data, voice and video
  • UL verified and meets TIA/EIA‑568‑B‑2.1 draft 9
  • Bonded pairs maintain twist spacing to reduce return loss
  • Snagless molded boot prevents catches and adds strain relief

Specifications

BrandC2G
ModelCTG-27136

Questions about this item

What type of network ports must my router or switch have for this CTG-27136 cable to connect?

The cable is built to the TIA/EIA-568-B-2.1 draft 9 standard, so it plugs into any standard Gigabit Ethernet port using the 8P8C interface defined by that specification.

Will this 50 ft Cat6 cable run at full speed when linked to older Cat5e patch panels or wall jacks?

The link will negotiate to the lowest common category, so Cat5e components will limit the channel to 100 MHz performance even though this cable is verified to 550 MHz.

How can I confirm the 550 MHz bandwidth rating is actually met after installation?

Use a qualified cable certifier that tests to the TIA/EIA-568-B-2.1 draft 9 limits; a passing report at 550 MHz proves the installed link meets the rated performance.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.