Cables To Go 28711 Cat5e network ethernet cable 100 ft shielded black

100 ft Shielded Cat5e Patch Cable

This 100 ft shielded Cat5e patch cable uses 4-pair 24 AWG stranded conductors with foil shielding and a drain wire to resist EMI and RFI interference. It is built for installers and network managers who need reliable Fast Ethernet and Gigabit links over longer runs in electrically noisy environments. The black PVC jacket and moulded snagless boots add durability for permanent or semi-permanent installations. TIA/EIA certification and 50 micron gold-plated RJ45 contacts ensure compliance with Cat5e performance requirements.

Upgrade from Unshielded or Shorter Cables

Replacing an unshielded patch cable with this shielded version is worthwhile when cables run near power lines, fluorescent ballasts or industrial equipment that inject noise into the signal path. The jump is also justified when a 100 ft reach is required and the existing cable falls short or shows intermittent errors on a Gigabit link. If the current run is short, stays in a quiet office and already passes certification testing, the extra shielding and length add cost without measurable benefit.

Verify Connector Type and Routing Space

Before ordering, confirm that both network ports accept standard RJ45 male plugs and that the 100 ft length can be routed without exceeding the 100 metre channel limit for Cat5e. Check that the pathway can accommodate the shielded cable’s slightly larger diameter and that a drain wire connection is available at the patch panel or switch if grounding is required. The cable is wired to the TSB 568B (AT&T 258A) pinout, so ensure the existing infrastructure follows the same wiring scheme.