Innovation First, Inc. 1UCMA-137 1U Cable Management Arm 19" 28.5"-33" computer accessory
- Product Type:Cable…
- Panel Width:19" Rac…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Cables To Go
A 10 ft Cat6 unshielded patch cable with 28AWG slim construction that is 36% thinner than standard Cat5e cables and snagless RJ-45 connectors
This 10 ft Cat6 unshielded patch cable uses 28AWG conductors that reduce its diameter by 36 percent compared with standard Cat5e cables. The slimmer profile makes routing easier in tight cable-management channels and dense patch panels. It is a new component ready for immediate installation.
The cable meets the ANSI/TIA-568-C.2 standard for patch-cord performance, so attenuation and crosstalk remain within specification over the full 10 ft length. Snagless boots protect the RJ-45 locking tabs during repeated re-seating, preserving reliable contact through frequent moves. Unshielded construction keeps the cable lightweight and flexible for permanent or temporary runs.
The 28AWG wire size determines both the reduced diameter and the maximum recommended run length for gigabit speeds. Builders who need longer distances or shielded protection for noisy environments should select a different gauge or shielded variant. This cable suits short, high-density connections where space is the primary constraint.
| Brand | C2G |
|---|---|
| Model | 01083 |
| Type | Consumer Electronics |
| Cat | 6 |
| Connector A | RJ-45 Male |
| Connector B | RJ-45 Male |
| Length | 10 ft. |
| Color | Blue |
| Shielded | No |
| Features | 36% reduction in diameter compared to standard Cat5e cables Snagless connector design Meets the ANSI/TIA-568-C.2 standard for Patch Cord Performance 28AWG construction |
| Shipping weight | 0.23 kg |
| Package size | 152 × 102 × 51 mm |
The 28AWG conductors meet ANSI/TIA-568-C.2 patch cord performance, so signal loss and heat remain within Cat6 limits for 10 ft runs.
Both ends use RJ-45 male connectors, so each connected device needs a standard RJ-45 jack — switches, routers, PCs, or patch panels.
The slim 36% reduced diameter and snagless design allow tighter side-by-side routing with legacy Cat5e cables in existing panels.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?